Loading ...
Loading ...
Loading ...
SECTION3: ASSEMBLINGYOURLAWNMOWER
RemovingUnitFromCarton
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open.
• Remove loose parts included with unit (i.e.,
operator's manual, oil, etc.).
• Cut corners and lay carton down flat. Remove
packing material.
• Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
NOTE: Make sure not to crimp cables while removing
loose parts or the entire unit from the carton.
NOTE: The indentation in your mowing deck is
intentional and not a defect. It allows the manufacturer
different configurations than the one you currently
have. See Figure 1.
Indentation
Intentional
Figure I
ToolsRequired
• Pair of Pliers
• Funnel
NOTE: Reference to right or left hand side of the mower
and/or front or behind the mower is observed from the
operating position.
HardwarePack
Please identify each piece of the
hardware pack as shown in
figure here.
AssemblingHandle
?
Wing Carriage
Nut(2) Bolt (2)
Remove grass bag from the unit and set it out of the
way. See Figure 2 (step 1).
Remove any packing material which may be
between the upper and lower handles for shipping
purposes.
2. Lift lower handle
Move bag
away
3. Lift upper
handle
Figure 2
Raise the lower handle in the direction shown in
Figure 2 (step 2) till it snaps into place.
Raise the upper handle in the direction shown in
Figure 2 (step 3). Tighten the wing nuts which are
already on the handle. See Figure 3.
__ Upper Handle
ower Handle
Tighten this
= wing nut
\
Figure 3
NOTE: Make sure to route the cables inside the lower
handle. Also do not crimp the cables while rifting the
handle up.
• For shipping purposes, the hairpin clip is placed in
the outer hole of the weld pin on the lower handle.
Remove the hairpin clip from the outer hole of the
weld pin. See Figure 4.
• Using a pair of pliers, insert the hairpin clip into the
inner hole on the weld pin. Repeat on other side.
See Figure 4.
Loading ...
Loading ...
Loading ...