Loading ...
HOW TO TRANSFER THE DOOR HINGE LOCATION OF
A REVERSIBLE DOOR
For your convenience, this door can be reversed by changing the position of the door hinge assembly.
1. Gently layde refrigerator on its back.
2, Unscrew the leg at opening side and set aside. *There may be a screw next to the leg; if so unscrew it.
Otherwise unable to attach the hinge.
3. Unscrew two screws (some models have 3 screws) at the bottom hinge, remove the leg, a hinge and a
shaft.
4. Unscrew two screws at the bottom of the door and remove the door stopper, then transfer them to the other
side.
5. Pull the door toward you, and set it at the side. (We recommended putting the door on a blanket to avoid
scratches.)
6. Remove the shaft carefully from the top table as using the screwdriver and relocate itto the other side.
7. Remove the hinge collar cap from the door cap, and then relocate it to the other side.
8. Reattach the door to the refrigerator cabinet toward the shaft at the top table and the bottom of the door hole
has to meet with the shaft at the bottom hinge.
9. Reattach the hinge with two screws (some models have 3 screws), the leg and also the shaft with the hinge.
10. Now your door has been reversed. The following points should be checked.
A. Make sure the door is on straight.
B. Make sure that there is no space between the door gasket and the refrigerator unit itself when the door is
closed.
C. Make sure that the gasket on the hinge side is not caught between the door and the unit when the door is
opened or closed. (If the door is forced closed when the gasket is caught, the gasket may be damaged.)
When checking the above points, ifit is discovered that the door is not installed properly (this isapt to happen
at the first try), loosen the screws holding the lower hinge, straighten the door and tighten the screws slowly
with the socket wrench. After making sure that the door is installed correctly, tighten all the screws holding
the hinge. If they are not tightened, the door may slip put of position or there may be an opening between the
door and the unit.
11. Stand the unit back in the upright position.
Wait 3 hours before plug in the power cord.
S H_je CollarCap
Loading ...
Loading ...
Loading ...