Loading ...
Loading ...
Loading ...
Ⅲ.Printing methods
Ⅳ.Trouble shooting for transfer quality
Adjust pressure to your requirement (Neither too tight nor too loose),
Plug in the power cord and turn the power switch ON.
The temperature starts to rise.Set the Initial temperature,Highest Temperature an
press time.
Once the temperature rise to the Initial temperature,the buzzer will send out a shot
“BEEF” sound.
Press the button once.Then Place the object (i.e. T shirt) on press bed.Pull
down the handle to press the object.
Wait for the time ends up with a long buzzer sound.(Note: There will be about 5s
time for long buzzer to notify you it has finished,and after that will appear 5s for
short buzzer to notify you whether you still go on the next work,if not the
temperature will fall down to the Initial temperature )
Work finish and take out object.
Turn off the power switch.
Pale Color:The temperature is too low/the pressure is not correct/or not pressed
long enough.
Blurring Pattern:Too much transfer time causes proliferation.
Part Blurring of Pattern:Heat was not distributed correctly through heat plate.
Allow more time between press operations.Pressure distribution can also be the
cause,which can be set on the four plate surface adjusters.Please note that it has
been factory set and there should be no need to adjust them.
Dull Surface of Pattern:The pressure is too lager or the temperature is too high.
Scarred Pattern:Transfer time is too long.
Different Pattern Color:The pressure is not correct or the transfer paper is poor quality.
Adhesive Paper:the temperature is too high or poor printing ink.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
- 14 -
Loading ...