Loading ...
Loading ...
Loading ...
INSTALLATIONREQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
[] 8" (20 cm) or 10" (25 cm) [] Security T-20 TORX_'tdriver
pipe wrench [] Level
[] 8" (20 cm) or 10" (25 cm) [] 5/16" open-end wrench
adjustable wrench
[] Vent clamps
[] Flat-blade screwdriver
[] Pipe-joint compound
[] Phillips screwdriver resistant to LP gas
[] Adjustable wrench that [] Caulk gun and caulk (for
opens to 1" (25 mm) or 1" installing new exhaust vent)
(25 mm) hex-head socket
wrench [] Pliers
[] Putty knife
Parts supplied
Remove parts bag from dryer drum. Check that all parts were
included.
[] 10-32 x 5/16" serrated screw (4)
[] Security cotter pin (2)
1 ® TORX is a registered trademark of Acument Intellectual Properties, LLC.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Do not install in a garage.
Failure to do so can result in death, explosion, or fire.
If installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
[] Check code requirements: Some codes limit or do not permit
installation of clothes dryers in closets or sleeping quarters.
Contact your local building inspector.
[] Make sure that lower edges of the cabinet, plus the back and
bottom sides of the dryer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See
"Recessed Area Installation Instructions" below for minimum
spacing requirements.
NOTE:
[] The dryer must not be installed in an area where it will be
exposed to water and/or weather.
[] This dryer must not be installed in a closet with a door.
............................................................................................................................................................... i
Recessed Area Installation instructions
This dryer may be installed in a recessed area. Minimum
installation clearances can be found on the rear of the dryer.
The dryer must be exhausted outdoors.
Minimum Installation Clearances
Back Sides Top Front
IRecessedl 2in, I 0in, I 12in, I -- I
(50 mm) (0mm) (300 mm)
-_1 j_-2" (50 mm_
0
0
+
+
12"
(300 mm)
+
j--
+
(0mm)
r---I::: E3
0"(0mm)-_ll/l_ _l'-l__l,0" (0mm)
Recessed Recessed
side view frontview
Additional clearances for wall, door, and floor moldings may be required
or if external exhaust elbow is used.
5
Loading ...
Loading ...
Loading ...