Loading ...
Loading ...
Loading ...
12.13 End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active).
In the display all washing phase
indicators become steady and the time
area shows
.
The indicator of the Start/Pause button
goes off.
The door unlocks and the indicator
goes off.
flashes at the end of the
programme in case of overloaded drum.
1. Press the On/Off button to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last
selected programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
12.14 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start/
Pause button.
Press the On/Off button to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the On/Off button to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
13. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
13.1 Complete wash&dry
programmes
Non-automatic wash&dry
programmes
In some washing programmes, you can
combine Wash and Dry mode for running
a complete wash&dry programme.
Proceed as follows:
1. After loading laundry and detergent,
press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme. The display
shows the default temperature and
spin. If necessary, change them
according to your laundry. The
display also shows the maximum
recommended load for washing
phase.
5. Set the desired options, if there are
available.
6. Touch the Mode button once to
activate also the drying function. The
Wash and Dry indicators come on.
www.aeg.com32
Loading ...
Loading ...
Loading ...