Loading ...
Loading ...
Loading ...
How To Install The Speed Control Rod
1. Put the speed select lever into the
sixth gear position.
2. Attach the speed control rod (end
with 90 ° bend) to the speed select
bracket with washer and cotter
pin. See Figure 10.
3. Put the speed select lever into the
first gear position.
4. Attach the trunnion, located on the
bottom end of the speed control
rod, to the shift yoke assembly.
See Figure 11. The fasteners are
attached to the trunnion at the
factory.
5. The length ot the trunnion and
speed control rod have been pre-
adjusted at the factory. If an adjust-
ment is required, see "How To
Adjust The Friction Wheel" in the
Service And Adjustment section.
6. Make sure the speed select lever
functions correctly. Move the speed
select lever through all speeds.
Speed
Control
Rod
Speed
Select
Bracket
\
Cotter Pin
Speed Select
Lever
Washer
Cotter Pin
/
_ Figure 10
Speed Control Rod
Trunnion
Shift Yoke
Washer
Figure 11
How To Assemble The Chute Deflector
1. Remove the carriage bolt. See
Figure 12.
4.
2. Raise the chute deflector into op-
erating position. 5.
3. Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of carriage bolt on
the inside of the flange.
Fasten with washer and Iocknut.
Tighten Iocknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
Chute
Deflector
Operating Position j._
\
/
Carriage,_
Bolt
F-021050L
Flang_ Washer Nut #,
1o
Figure 12
Loading ...
Loading ...
Loading ...