Loading ...
Loading ...
Loading ...
B D B
To replace brushes
Align posts (A) on both ends of brush
assembly with slots (B) in cleaner hous-
ing
Make sure that the square post (C) also
aligns with the square hole (D) Turn
brushes slightly until post fits easily into
hole
Press brush assembly firmly to snap into
place
Storage
Before storing:
• Empty clean water tank and let air
dry Replace on deep cleaner
• Unused detergent can be stored in
the detergent container
• Empty recovery tank, rinse tank
and lid thoroughly with clean water
and let air dry
Allow brushes and underside of deep
cleaner to air dry thoroughly before
storing deep cleaner on a carpeted or
wood surface.
Do not store deep cleaner with a full
clean water tank in place.
Lubrication
The motor is equipped with bearings
which contain sufficient lubrication for
the life of the motor The addition of
lubricant could cause damage Do not
add lubricant to motor bearings.
If a minor problem occurs, it usually can
be solved quite easily when the cause is
found by using the check list below
Possible cause
Possible solution
• Not firmly plugged in
• Plug unit in firmly
• No voltage in wall receptacle
• Check fuse or breaker
• Blown fuse/tripped breaker
• Replace fuse/reset breaker
Possible cause
Possible solution
• Recovery tank full/automatic shut
off engaged
• Remove and empty recovery tank
• Blockage in tool on end of hose
• Remove tool and clear blockage
• Recovery tank lid not on correctly
• Make sure lid is on securely
• Water tank empty, but detergent
remains
• Fill water tank
Possible cause
Possible solution
• Clean water tank not firmly in place
• Make sure tank is securely locked in
position
• Clean water tank or detergent
container empty
• Refill container according to instruc-
tions for surface being cleaned
• Recovery tank lid not on
correctly
• Make sure lid is firmly in place
Possible cause
Possible solution
• Valve cap clogged
• Remove and clean valve cap (see fol-
lowing instructions)
1 Remove clean water tank
A
3 Align slots (B) on cap with tabs (C) in
opening
Turn cap clockwise to tighten
Possible cause
Possible solution
• Dirty filter screen on bottom of unit
• Clean screen as shown in Fig. 3-2
• Setting selector on OFF
• Move setting selector to ON
2 Turn valve cap (A) counterclockwise
and remove
Soak valve cap in warm water for at
least 15 minutes Wipe cap dry
Continued -P 15
Loading ...
Loading ...