GE - General Electric PSS26MGPAWW GE refrigerator - p series

User Manual - Page 12

For PSS26MGPAWW.

PDF File Manual, 44 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Abouttheautomaticicemaker.
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Ondispensermodels,to Automatic Icemaker
access ice or reach the
power switch:
o Lift the bin, then pullit
forward until the bin stops,
The icemaker will produce seven cubes
per cycle----approximately 100-130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of"door openings
and otber use conditions.
K the reliigerator is operated before the
water connection is made to tbe icemake_;
set tbe power switch in the 0 (off) position.
When the refrigerator has been connected
to tbe water supply, set tbe power switch to
tbe / (on)position.
The icemaker will fillwitb water wben it
coolsreliigeratorto 15°Fmay(-10°C)'take12A tone*_dy24 hoursinst_ledto begin
making ice cubes.
You will hear a buzzing sound each time
tbe icemaker fills witb water.
Throw away the first few batches of ice to
allow tbe water line to cleal:
Be sure nothing interferes witb the sweep
o Lowerthe bin to access ice
or reach the power switch.
NOTE:In order to take furl advantage
of the tilt-out ice bin, only store items
on the sheff below the ice bin that
are no taller than the lowest point
on the bin.
_ Lift the bin, thenpull it
forward until the bin stops.
_ Lift and puff forward again
to remove the bin,
of tbe feeler arm.
When the bin fills to tbe level of the lieder
arm, tbe icemaker will stop producing
ice. It is normal for several cubes to be
joined togetber.
If ice is not used fi'equently, old ice cubes
will become cloudy, taste stale and shrink.
Specialnotesaboutdispensermodels:
_ Dispenser models bare a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and it will hold itself
up while you take ice out or turn tbe
icemaker power switch on and olE
Be sure to put tim bin back in place
before closing the door.
_ To restore your ice level from an empty
bucket stage, the following steps axe
recommended:
I1_ 12 hours after tbe fiL'Stbatch of ice
has fallen into tbe bin, dispense
3 to 4 cubes.
After an additional 6 hours, dispense
3 to 4 cubes again.
These steps will restore your ice level
in the shortest amount of time.
NOTE:Inhomeswithlower4hat>averagewater
pressure,youmayheartheicemakercyclemultiple
timeswhenmakingonebatchofice.
Removing Ice Bin (dispenser models)
cMYrlON:Theice binis heavywhen full.
Set tbe power switch to the 0 (Off)position
beibre removing tbe bin.
Whenreplacingthebin,be sure to press it
firmly into place. If it does not go all tbe
way back, remove it and rotate the drive
mechanism 1/4 rum. Then push tbe bin
back again.
12
Dispenser Models only
Loading ...
Loading ...
Loading ...