Loading ...
Loading ...
Loading ...
18
Customer Care Center, 1-800-898-1879, www.askona.com
INSTALLATION
Read these instructions carefully and completely before
you install the machine. The installation should be carried
and ordinances for electrical and plumbing connections.
Cosmetic damage must be reported to your dealer within
washer, thoroughly check the unit for cosmetic damage.
LEVELING THE MACHINE
It is important that the machine is level to prevent excessive
vibrations during spin cycles. Each foot of the washer is
Once it is level, securely tighten the lock nuts on the feet to
prevent excessive vibration during spin cycles.
Be sure to tighten the
lock nuts securely
when you level the
machine.
WATER SUPPLY CONNECTION
Since ASKO washers have a built-in heating element,
you only need a cold water inlet. The connection should
hose supplied with the washer. (The inlet hose is marked
for correct connection.) The water pressure must be in the
supply pipe. If a new supply pipe has been installed for
NOTE!
If the unit is installed on a second storey, follow local
building codes. We recommend installing a drip pan.
DRAIN OUTLET CONNECTION
The machine is supplied with the outlet hose already
attached. The hose should be extended over a suitable
sink edge or drain pipe at a height of 24” to 36” (610 mm to
914 mm) above the bottom of the unit. (The lower height is
preferable.) Make sure the hose is not kinked.
24" to 36"
NOTE!
If the hose is extended, the internal diameter of the
coupling must not be less than ½”.
WARNING
Do not extend the drain hose higher than 36” (914 mm)
from the bottom of the unit.
ELECTRICAL INSTALLATION
is intended for connection to an ASKO Dryer, which is
equipped with a matching receptacle. The plug supplied
with the washer can only be used with an ASKO Dryer. If
the washer is used separately or with another dryer, it must
be on a separate 208-240 V single-phase circuit.
If the machine is to be used in a wet area, the supply must
be protected by a residual current device.
As supplied: 208-240 V, 60 Hz, 2000 heating element,15 A
timed delayed fuse is required.
WARNING
Connection to a permanently wired supply point must be
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of
malfunction or breakdown, grounding will reduce the risk
of electric shock by providing a path of least resistance
for electric current. This appliance is equipped with a
cord having an equipment-grounding conductor and a
grounding plug. The plug must be plugged into
an appropriate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances.
Loading ...
Loading ...
Loading ...