Loading ...
Loading ...
Loading ...
Assembly (continued)
A Phillps head screw driver is required.
Do not plug in power
cord to power outlet, make sure
plug is disconnected before
assembling the wet/dry vac.
UNPACKING YOUR WET/DRY
VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is
disconnected from the outlet.
(Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection
tank and place on a flat clean
surface. (Fig. 3)
4. Remove the contents from inside the
collection tank, make sure you have
all contents as listed on carton
content list on page 5. (Fig. 4)
5. With the power head removed, turn
the collection tank upside down.
insert the four caster assemblies
into each socket. Apply pressure
until caster assemblies fully seated.
(Fig. 5) Secure them with the screws
provided. Do not over tighten the
screws.
6. For dry vacuum cleaning, install the
supplied reusable cloth filter. (fig. 6)
See page 12 for filter installation.
7. For wet vacuum cleaning, install the
supplied foam filter. (fig. 7) See page
13 for filter installation.
8. Place the power head back on the
collection tank, aligning the top
section with the latches, and snap
into place. (Fig. 8 & Fig. 9)
9. insert the locking end of the hose
into the port on the collection tank
and turn to lock in to place. (Fig. 10)
10. Choose the desired accessory and
insert onto the end of the hose
(Fig. 11)
11. After vac use, store hose,
accessories and cord as illustrated
on page 14.
Loading ...
Loading ...
Loading ...