Loading ...
Loading ...
Loading ...
• Do not ground to a gas pipe.
• Check with a qualified electrician if you are not sure the
washer is properly grounded.
• Do not have a fuse in the neutral or ground circuit.
1. 3 prong grounding plug
2. 3 prong grounding-type outlet
3. Ground prong
4. Power ,supply cord
GROUNDING INSTRUCTIONS
For a grounded, cord-connected washer:
This washer must be grounded. In the event of a
malfunction or breakdown, grounding will reduce the
risk of electrical shock by providing a path of least
resistance for electric current. This washer is
equipped with a cord having an equipment-grounding
conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
WARNING: Improper connection of the
equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or
serviceman if you are in doubt as to whether the
appliance is properly grounded.
Do not modify the plug provided with the appliance -
if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
For a permanently connected washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or
lead on the appliance.
INSTALLATION
INSTRUCTIONS
Install the rear self-adjusting feet
1. To prevent floor damage, set the washer onto cardboard.
2. Move the washer to within approximately 3 ft (90 cm) of the
final location.
3. Prop up the rear of the washer about 4 in. (10.2 cm) with a
wood block or similar object. The block needs to suppoiff the
weight of the washer.
4. Install the self-adjusting rear feet by pushing all the way up
into the hole shown below.
_z
5. Tilt the washer forward and remove the wood block. Gently
lower the washer to the floor.
Install the front leveling feet
6. Prop up the front of the washer about 4 in. (10.2 cm) with a
wood block or similar object. The block needs to suppoit the
weight of the washer.
7. Screw the lock nut onto each foot to within 1 in. (2.5 cm) of
the base.
1 ,,
(2.5 cm)
8. Screw the feet into the correct holes at the front corner of the
washer until the nuts touch the washer,
NOTE: Do not tighten the nuts until the washer is level,
9. Tilt the washer back and remove the wood block. Gently
lower the washer to the floor.
Loading ...
Loading ...
Loading ...