Loading ...
Loading ...
Loading ...
First Steps
This Use & Core Guide provides specific operating
instructions for your model. Use the refrigerator only os
instructed in this Use & Care Guide. Before starting the
refrigerator, follow these important first steps.
Installation
° Choose o ploce that is near o grounded electricol outlet.
Do Not use on extension cord or on adapter plug.
° For the most emcient operation, the refrigerator should
be located where surrounding temperatures wiii not drop
below 40°F (5°C) or exceed 110°F (43°C). Additional
compressor heaters ore not recommended.
° Allow space around the unit for good air circulation.
Leave a 3 inch (75 mm) space on oil sides of the
refrigerator for adequate circulation.
Leveling
3"(75mm)
installation
NOTE
The exterior wafts of the refrigerator may become quite
warm as the compressor works to transfer heat from
the inside. Temperatures as much as 30°F warmer than
room temperature con be expected. For this reason it is
particularly important in hotter climates to allow enough
space for air circulation around your refrigerator.
The refrigerator must have oil bottom corners resting firmly
on o solid floor. The floor must be strong enough to support
o fully loaded refrigerator. NOTE: It is Very important for
your refrigerator to be level in order to function properly. If
the refrigerator is not leveled during installation, the door
may be misoligned and not close or seal properly, causing
cooling, frosh or moisture problems.
To Level Your Refrigerator:
After
discarding
crating screws
and wood
bose, use o
carpenter's
level to
level the
refrigerator
from front-to-
Plastic
Leveling Feet
I
Crating
Screw
..o
back. Adjust
the plastic
leveling feet _
in front, 1/2
bubble higher,
so that the .
door closes '-.
easily when
left halfway
open.
Discard The (4) Crat ng Screws
• And (2) Wood Bases
%
Unpacking and Leveling -- Upright Models
Cleaning
° Wash any removable parts of the refrigerator interior
ond exterior with mild detergent ond warm water. Wipe
dry. Do not use harsh cleaners on these surfaces.
° Do not use razor blodes or other sharp instruments,
which con scratch the opplionce surfoce when removing
adhesive Iobels. Any glue left from the tape con be
removed with o mixture of warm water ond mild
detergent, or touch the residue with the sticky side of
tape olreody removed. Do not remove the serial plate.
Door Removal
_ CAUTION
To allow door to dose and seal properly, DO NOT let food
packages extend past the front of shelves.
Shelf Front
Loading ...
Loading ...
Loading ...