Loading ...
Loading ...
Loading ...
PureSource2 TM * Ice and Water Front Filter (some models)
NOTE: If you purchased a refrigerator with a PureSource2 TM'Ice and Water front filter, please read the following use
and care information. This ice and water filter system fibers water to your ice maker and water dispenser, itis located in
the upper right front corner of the fresh food compartment.
System Startup:
Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter.
The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser
Works section to properly fill the system with water.
Changing the Filter:
Water conditions vary throughout the world, but changing the water filter every
6 - 9 months normally will ensure the highest possible water quality. The Filter
Status light wilt turn red after approximately 400 gallons of water has flowed
through the ice and water dispenser. Also, if the filter has been in a refrigerator
that has not been in use for awhile (during moving for example), change the filter
before reinstalling the refrigerator. The dispenser system will also operate without
filtration (with filter cartridge removed and bypass installed).
Order new tilter cartridges through the
dealer where you bought the refrigerator,
contact the Customer Care Center at
t -800-944-9044, or go to our web site at
www.friaidaire.com. It might be good to
order some filter cartridges when you first
install your refrigerator. Be sure to ask for
the FC-100 PureSource rM*replacement
cartridge.
The PureSource2 r_ _ce and
Water Filter System NGFC
2000 with the PureSource2 r_
cartridge FC 100 is tested and
cedified by NSF International,
the nationally recognized and respected,
not for profit, certification organization for
public health safety. The PureSource2 _M"
Filter system is tested and certified to ANSI/
NSF Standards 42 and 53. See
performance data sheet for specifications.
This system should not be used on water
that is microbiologicatly unsafe or with water
of unknown quality unless the water has
been adequately disinfected before or after
traveling through the filtration system.
• Rated Capacity - 400 gallons
• Rated service flow - .5 GPM
• Maximum Rated Pressure - t00 PSI
• Maximum Operating Temp. - 100° F
To change filter:
It is not necessary to turn the water supply off to change the filter.
I. Turn the ice maker's power switch to the Off ("O") position (See illustration
on page 13).
2. Push the Filter Release Button, located to the right of the filter cartridge,
to release the filter from the housing. To minimize the possibility of the
filter failing out of the housing during removal, itwould be best to hoedthe
filter as it moves out toward you.
3. Pull the old filter cartridge straight out of the housing.
4. Discard the old filter.
5. Remove the new filter cartridge from the packaging and insert into the
filter housing the same way the old one came out.
6. When the cartridge is almost in,you will feelit stop against the clip assembly
in the back of the housing.The clip assembly holds the filter cartridge
firmly in place. At this point, you will need to push firmly until the cartridge
snaps fully in place. When completely in place, the front of the filter cartridge
will be flush with the front of the housing.
7. Turn the ice maker's power switch to the On (1") position.
8. Fill a glass with water. As you are doing this, check for leaks at the filter
housing. There will be noticable spurts and sputters as the system pushes
the air out through the system and out the dispenser nozzle.This is normal
9. After you have run one glass of water, continue to flush the system for
approximately 3 minutes to assure that the purest water possible is stored
in the water storage tank.
* White Westinghouse uses the name CrystalClear h_steadof PureSource, butthey are the same filter
16
Loading ...
Loading ...
Loading ...