Loading ...
Loading ...
Loading ...
13
Half
Load
Power
Scrub
Plus
Auto
Wash
Regular
Wash
Quick
Wash
Refill
Rinse
Agent
Sanitized
Hidden Top Controls
1. Open the dishwasher door just far enough to expose the
control panel.
2. Press the On/O button to turn the unit o.
3. Wait at least ten seconds or until the water noises stop
before opening the dishwasher door.
4. To resume the cycle, press the On/O button and close
the dishwasher door.
Exposed Front Controls
1. Press the On/O button to turn the unit o.
2. Wait at least ten seconds or until the water noises stop
before opening the dishwasher door.
3. To resume the cycle, close the dishwasher door and then
press the On/O button.
Dishware Drying
At the end of the cycle the dishwasher will stop and a period
of condensation drying will follow. After drying, the cycle is
complete and depending on your model:
the “Clean” light will illuminate OR•
the completion signal will sound OR•
the countdown display will show “0” (select models) OR•
the “Sanitized” light may appear. When the “Sanitized” light •
“ ” appears, it means that the dishware and kitchenware
that was just washed has been sanitized according to the
requirements of the National Sanitation Foundation (NSF).
For more information on NSF certication, go to the Wash
Cycle Information section of this manual.
OPERATING THE DISHWASHER
To start the dishwasher, follow the instructions in Figure 28 and
29 below.
WARNING
You could be seriously scalded if you allow hot water to
splash out of the dishwasher. OPEN THE DOOR CAREFULLY
during any wash or rinse cycle. Do not fully open the door
until water noises have stopped.
Canceling or Changing a Cycle
To cancel or change a cycle, open the dishwasher door far
enough to expose the control buttons then press and hold for
three seconds the two buttons labeled “Cancel/Reset” as shown
here.
Close the door and wait until the dishwasher completes the
cycle (approximately 1 minute). Open the door and press the
ON/OFF button. You may now begin a new cycle.
Interrupting a Cycle
NOTE: Should you need to interrupt a cycle (to add or remove
an item, to add detergent, etc.), it is best to do so within the
rst 30 minutes of the cycle.
Cancel / Reset
1) Open the door
2) Turn on
3) Select a cycle
4) Close the
door to start
1) Close the door
2) Turn on
3) Select a cycle
4) The unit will
then start
FIGURE 27
FIGURE 28 - HIDDEN TOP CONTROLS
FIGURE 29- EXPOSED FRONT CONTROLS
Loading ...
Loading ...
Loading ...