Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Won't Drain/ Lowvoltage or using Check electrical source or call
Won't Spin/ an extension cord. electrician. Donot use extension
Wet Loads cords.
(cont.)
Cold rinses. Cold rinses leave loads wetter than
warm rinses,This is normal.
Continues Drain hose is less than Raise the drain hose (see
to Fill/ 39 in (99 cm) above floor. "Installation Requirements").
Continues
to Drain/ Drain hose fits tightly into Adjust drain hose for loose fit
Cycle Stuck standpipe. (see"Installation Instructions").
Drain hose taped into Donot seal off drain hose withtape.
standpipe. The drain hose needs an air gap,
Washer Makes Load is unbalanced. Redistribute load.
Noise
Washer is not level. Levelwasher. Reset rear legs
Rearleveling legs not set, (see"Installation Instructions").
Nutson front feet not tight. Tighten nuts (see "Installation
Instructions"),
Yellowshipping strap with Removestrap with cotter pins
cotter pins not completely (see"Installation Instructions").
removed.
Floor not strong enough Relocatewasher (see "Installation
to support washer. Requirements").
Gears engaging after drain This is normal.
and before spin,
Upper part of agitator clicks This is normal.
during wash.
Water inlet valve Clean screens.
screens are plugged.
Won't Water is turned off. Turnon water.
Fill/Won't
Rinse/Won't Hotand cold hoses are Reversehoses (see "Installation
Agitate/ reversed. Instructions"),
Wrong Inlet hose is kinked. Straighten hoses.
Temperature
Timer dial is not lined up, Turntimer knob to the right slightly
and pull to start.
Powercord not plugged in. Plug into a grounded 3 prong outlet.
29
Loading ...
Loading ...
Loading ...