Loading ...
Loading ...
Loading ...
5
Setting the temperature control
To set the temperature:
1. Connect the power cord to a properly grounded outlet. In the event of a power interruption, all
previous temperature settings are automatically erased and the compartment will default to a
preset temperature of 5°C (41°F).
2. Set the desired cooling temperature by pressing the corresponding buttons or to raise or
lower the set temperature. Each depression of the button will scroll through the available
temperature settings, raising or lowering the set temperature 1 degree at a time. The temperature
selected will flash in the LED display for approximately 5 seconds, then revert back to displaying
the internal temperature of that zone.
The temperature setting can be adjusted from 1℃ to 18℃ (34°F to 65°F).
3. To view the “set” temperature at any time, press either button or once and the “set”
temperature will flash in the LED display for 5 seconds.
RUN
Indicator light illuminates to signify the cooling mode is currently in operation.
LIGHT/LOCK
You can turn the interior light ON or OFF by pushing the button marked with the “bulb” symbol.
The light will turn off automatically if it remains ON for 10 minutes. Pushing the button marked with
the “bulb” symbol again will turn the light back on. For optimum storage of wine, keep the light off
except when viewing.
If you press and hold the button for 3 seconds, the control panel will lock and cannot be
operated again until the button is pressed again. After that, it will operate normally.
Temperature Conversion
This unit has the option to display temperatures in either Celsius or Fahrenheit. To change the setting,
press and hold both buttons ( and ) simultaneously for approximately 3 seconds.
NOTES:
If the unit is unplugged or turned off, or if there has been a power failure, you must wait 3 to 5
minutes before restarting the unit. If you attempt to restart before this time delay, the appliance will
not start.
When you use the appliance for the first time, or restart it after it has been shut off for a long time,
there could be a few degrees variance between the temperature you select and the one indicated
on the display. This is normal and due to the length of inactivation time. Once the appliance has
been running for a few hours, everything will be back to normal.
You may notice condensation on the outer surface of the glass door. This occurs when water vapor
from the air contacts the cold surface of the door and the vapor condenses on the glass, causing a
fogging effect. In extreme situations, water can even drip off the door, indicating excessive humidity
in the environment.
If the appliance has been off for less than 5 minutes, the compressor will not restart at once when
is pressed. This behavior is built into the control system to protect the compressor.
Loading ...
Loading ...
Loading ...