Loading ...
Loading ...
Loading ...
Check motor safety filter frequently.
If the motor safety filter, located in the bottom of
the dust bag cavity is dirty, remove it by pulling
forward out from under the ribs.
Foam __
Filter -
Wash the foam filter in warm soapy water.
Rinse and dry thoroughly by squeezing the filter
in your hand and letting it air dry.
DO NOT wash filter in the dishwasher.
DO NOT install damp filter.
Replace the foam filter by sliding it back into
place under the ribs in the dust bag cavity.
WARNING
Electric Shock Hazard
Do not operate the cleaner without
the motor safety filter. Be sure the
filter is dry and properly installed to
prevent motor failure and/or electric
shock.
Always unplug power cord from
electrical outlet before performing
any service on vacuum,
D onoWARNING
t operate without exhaust filter.
Your vacuum has a HEPA filter to trap fine dust
particles so that they are not exhausted into the
room air. If you use vacuum frequently, you
should replace the HEPA filter every 6 months.
Check the filter frequently. To prolong the
useful life of the filter, remove it and clean by
tapping it against a hard surface to remove dirt.
You may also brush or vacuum the dirt away.
DO NOT wash the HEPA filter or it will
lose its dust trappm
Pull the dust cover
forward. Remove
and lay aside.
J
Dust --
Cover
ability.
Remove the exhaust filter by pulling it out.
Exhaust_
Replace the
exhaust filter,
carefully
positioning it so
that it fits into the
frame, blue side
facing out.
Carefully replace the
dust cover by placing
tabs in slots and
pushing in until cover
snaps into place.
-14-
Loading ...
Loading ...
Loading ...