Loading ...
Loading ...
Loading ...
TO REPLACE BRUSHROLL
1. Slide the switch to the unlock position
and remove bottom plate.
2. Inspect condition of brushroll.
Replace brushroll if brushes are
worn down. To remove brushroll,
pull up and out of end slots in nozzle
housing. Insert ends of brushroll into
same slots to replace.
Note : Inspect belt to ensure that it
is in good condition, tf belt is
broken or cracked, replace belt
according to ToReplace Belt
instructions.
3. Insert the four tabs on edge of
bottom plate into slots on front of
tool. Pivot bottom plate down and
snap closed. Slide switch to lock
position to secure the bottom plate
in place.
TO REPLACE BELT
1. Remove bottom plate by sliding
switch to unlock position. See figure
in To Replace Brushroll instructions.
2. Loop one end of new belt around
shaft of pulley.
3. Loop other end of belt around
designated area for it on brushroll.
Insert brushroll into slots in nozzle
housing. See figure in To Replace
Brushroll instructions.
4. Fit turbo brush back together as
described in To Replace Brushroll
instructions.
17
Loading ...
Loading ...
Loading ...