GE - General Electric ZGG36L21ASS GE gas grill

User Manual - Page 10

For ZGG36L21ASS.

PDF File Manual, 16 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Installation
Outdoor Cooki_g (enters
ELECTRICAL SUPPLY
Models with rotisserie require 120V, 60Hz.
and cmmected to an individual properly
grounded branch circuit protected by a 15
amp circuit breaker or time delay filse.
The power cord on the rotisserie is equipped
with a three-prong (grotmding) plug which
mates with a standard three-prong grotmding
wall receptacle to minimize the possibility of
shock hazard fi_om this appliance.
If the electrical service provided does not
meet the above specifications, it is recom-
mended that a licensed electrician install an
approved outlet.
DO NOT UNDER ANY CIRCUMSTAN(:ES,
CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD.
For 27" wide built-in grills, locate the
electrical outlet on the left hand side within
reach of the rotisserie's 72" power cord.
For 36" and 48" wide built-in grills, locate
the electrical outlet on the right hand side
within reach of the rotisserie's 30" power
cord.
St
es[Jo "
Leaks
TEST FOR LEAKS
A complete gas tightness check must be
pertormed at the installation site.
Do not use the grill tmtil all com_ections have
been leak tested.
Repeat leak test alter each LP tank change.
Check to be sm'e the main valve on the LP
tank or the shut-off valve is in the "OFF"
position.
Make a soap solution of one part liquid
detergent and one part water.
The valve panel must be removed to check the
valves and fittings.
All control valves should be in the "OFF"
position.
Relnove the knobs.
On inodels equipped with Rotisserie, relnove
the satety valve pushbutton and tmsrrew the
stn'rotmding bezel.
Rem()ve the 4 screws holding the valve panel
to the grill.
Pull the panel outwards and m_plug the wires
fl'om the back of the rotaI T igniters.
If the grill has an optional rotisserie bm'ner,
remove the screws holding the inspection
cover in place.
TO TEST:
Apply the soap solution arotmd the
com_ections, valve and tubing.
Tm'n the gas supply on.
Check all comaections fi'om the supply line
or LP tank up to and including the manifl_ld
pipe assemblv.
If a leak is detected, turn gas supply to off
and tighten fittings. Tm'n the gas on and
check again.
To re-install the valve panel, re-comaect the
igniter wires and secm'e the panel with
original screws.
10
Loading ...
Loading ...
Loading ...