Loading ...
Loading ...
Loading ...
Connectionslocatedontherearofthe Dimensions _ units are not designed to be
appliance: stacked.
Power cord with plug.
H = hot water connection
C = cold water connection
Useful tools
The following tools are helpful:
1. Flat head screwdriver.
2. Socket wrench (1/2" / 13mm).
3. Closed wrench (1/2" / 13 mm).
4. Bubble Level.
2
4
a = 27.0 inches (686 mm)
b = 30.7 inches (780 mm)
c = 37.0 inches (940 mm)
d = 16.0 inches (407 mm)
Door opening angle 180 °
Approx. weight = 220 Ibs (100 kg)
Installation area
Never ground the washer to plastic
plumbing lines, gas lines or hot
water pipes.
This appliance must be installed on
a solid floor and well leveled due to
the higher spin speeds available. If
installing the machine on a wood
floor over a basement or on a
second floor, the floor may need to
be reinforced. Sound, vibration, and
risk of "walking" will be affected
depending on the structure and
stability of the floor surface where it
is installed.
If the washing machine is to be installed
on a weak wood floor consider the
following:
Soft floor surfaces, such as
carpets or surfaces with foam
backing, are not suitable. If
possible, place the washing
machine in a corner of the room.
Screw a water resistant wooden
board (at least 3/4" thick) to the
floor.
Secure the feet of the washing
machine with holding brackets.
Order the holding brackets (set)
from Bosch Customer Service
(WMZ 2200).
Units are not designed for under
counter installation
Pedestal Mounting
If mounting the washer on the Bosch
pedestal, follow the instructions sup-
plied with the pedestal.
Pedestal Accessory no.
WT71295 for solid white color
WT7 1295S for solid tone silver
D Install pedestal prior to
removing transport bolts.
Closet
If installing the washer in a closet,
observe the minimum distances
according to the following table:
Minimum Installation Clearances
Closet
Sides 1/4" (6 mm)
Top 12" (305 mm)
Rear 25" (64 mm)
Front 1/4" (6 mm)
Ventilation:
Top: 48 sq. in (310 sq. cm),
Bottom: 24 sq. in (155 sq. cm)
Checklist for Page
Installation
completely remove 4 8
shipping bolts
move the washer into place 8
connect the water supply line 8
and drain pipe
connect the electrical power 10
slide the washer into its final 11
location
level the washer as low as 11
possible
before first use, run a 15
cleaning cycle
Loading ...
Loading ...
Loading ...