Loading ...
Loading ...
Loading ...
3. Remove reverse (outside) V-belt.
4. Remove forward (inside) V-belt from
transmission pulley first and then from
engine pulley.
BELT REPLACEMENT
5. Install new forward (inside) V-belt to
engine pulley first then to transmission
pulley. Be sure belt is positioned on
inside groove of both pulleys, inside
all belt guides and rests on idler
pulley.
6. Before installing reverse (outside) V-
belt, turn belt "inside out". Twist so
wide, flat surface of belt is to inside.
7. Wrap V-belt around reverse idler
pulley and reassemble idler to idler
arm, Tighten securely. Be sure belt is
between reverse idlerpulley and idler
arm pin.
8. Install belt to outside groove of
transmission pulley. Be sure belt is
inside all belt guides and rests on
outside groove of engine pulley.
CHECK TINE OPERATION
9. See 'TINE OPERATION CHECK" in
this section of manual.
10. Replace belt guard.
FRONT VIEW REFERENCE
Reverse
FORWARD MOTION (INSIDE)V-BELT
Rev£: y
BeltGuide Foi:ward_ /
Idler "_ J
Pulley Tra/ns_on Pulley
REVERSE (OUTSIDE) V-BELT
Reverse IdlerPulley
Engin_
Po,ey",'-', 0 )
Forward_ j _ /
IdlerPulley
Reverse Idler Arm Reverse (OUTSIDE) V-Belt
Reverse
Idler
Idler
Pulley
Idler Pulley
Belt Guard
Bolt
Transmission
Pulley
ENGINE
Maintenance, repair, or replacement of
the emission control devices and sys-
tems, which are being done at the
customers expense, may be performed
by any non-road engine repair establish-
ment or individual. Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUST CARBURETOR
The carburelor has been preset at the
factory and adjustment should not be
necessary. However, engine perfor-
mance can be affected by differences in
fuel, temperature, altitude or load. If the
carburetor does need adjustment, contact
your nearest authorized service center/
department
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed. Overspeeding the
engine above the factory high speed
setting can be dangerous. If you think the
engine-governed high speed needs
adjusting, contact your nearest sears or
other qualified service center which has
the proper equipment and expedenoe to
make any necessary adjustments.
15
Loading ...
Loading ...
Loading ...