Loading ...
Loading ...
Loading ...
49-3000206 Rev 5 7
A
B
C
Power
Press to “wake up” the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Start and Pause
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle. Pressing Start
again will pause the cycle, the Start light may blink and “Pause” will display.
To continue the cycle, press Start again.
Display and Status Lights
The display shows the approximate time remaining until the end of the cycle. On some models, the dryer cycle
status (Sense, Drying, Damp and Cool) will be shown.
In addition, the display will show:
USING THE DRYER
Getting started
(WiFi)
(on some models)
Will allow your appliance to communicate with your smartphone for remote appliance
monitoring control and notifications.
Controls
The dryer is locked - will blink once if you press any pad or turn the cycle knob.
Check Filter The Check Filter light will stay on for 15 seconds after the cycle stops.
Check Vent
The Check Vent light indicates an issue has been found due to reduced airflow from a possible
blocked or restricted vent. Checking and/or cleaning the vent system is recommended. See the,
“Check Vent” light is on in the Troubleshooting Tips section.
(on some models)
Your dryer is equipped with Artificial Intelligence capabilities. This indicator will illuminate when
Washer Link is active, My Settings are being implemented based on your usage habits and
suggested actions are available through the SmartHQ app.
Loading ...
Loading ...
Loading ...