Loading ...
Loading ...
Loading ...
5
INSTALLATION
4
APPLIANCE DESCRIPTION
Control panel
Grill door
(where fitted)
Kick panel
Front adjustable feet
Hotplate
Oven door
GENERAL APPLIANCE DESCRIPTION
Location
This appliance must not be placed on a base� This appliance
must not be installed behind a decorative door�
The appliance has been designed to fit a 550mm gap in
kitchen cabinetry or have free space on either side� Ensure the
top of the hotplate is at least 10mm higher than the level of the
benchtop�
Electric hob models must not be installed in a corner; they
must be installed at least 100mm from the side wall�
Gas hob models must be installed with a minimum clearance
of 100mm to side walls made of unprotected combustible
material� For gas models, refer to section 6�10�1 in AS/NZS
5601�1 for all relevant clearance�
Clearance
to side wall
(refer notes
above)
600mm min�
to combustible
material
550mm
min�
1150mm
910mm
540mm
620mm
Anti-tilt plate
1�25m electrical
service cord (if fitted)
WARNING
WARNING
In order to avoid accidental tipping of the appliance (for
example, by a child climbing onto the open oven door),
the anti-tilt plate and stabilising bolt MUST be installed.
Following table outlines the distance between the floor
supporting the product and the surface supporting
cooking vessel:
Surface type
(supporting vessel)
Distance (mm)
Coil 910
Enamel Trivels 927
Ceramic Glass 903
Rear cover
25mm to
side of
bracket
Rear adjustable foot
Width 540mm
Anti-tilt plate
5mm clearance
Position anti-tilt plate to the rear wall and 25mm from side of
cupboard� Securely fix anti-tilt plate to the floor with fasteners�
Adjust levelling feet on cooker as required�
Stabilising bolt
Remove oven door - to be done by qualified personnel only�
(Refer to procedure)�
2� Remove screws from kick panel� To remove kick panel lift
kick panel upwards to release the two location tabs from
the holes in the bottom of the panel�
3� Position cooker into the ant-tilt plate and then mark the
position for the stability bolt hole on the floor�
4� Pull cooker out and drill the bolt hole, using a 6�5mm
masonry or wood drill bit� The bolt hole needs to be a
minimum of 30mm deep when fixing the oven to concrete�
5� Reposition cooker back into place and fit the stability
bolt through the slot and into the drilled hole�
6� If the cooker is placed on a base, measures must be
taken to prevent the appliance slipping from the base�
7� Carefully remove any protective plastic film to prevent
damage to the appliance�
WARNING
WARNING
For your safety this cooker is designed to be moved out of
position by a qualified person only.
The unit must be pushed up against the wall on installation.
On gas units check that the gas hose, if used, has not been
kinked during installation.
INSTALLATION
Do not store items on the cooking surface, to avoid a fire�
Unattended cooking on a hob with fat or oil can be dangerous
and may result in a fire�
Electric Separate Grill Oven depicted�
Loading ...
Loading ...
Loading ...