Loading ...
Loading ...
Loading ...
9
17621 South Susana Road, Rancho Dominguez, California 90221
info@vinotemp.com
INSTALLATION
• Remove all packing material before using your wine cooler.
• IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water and a soft cloth.
• This unit is designed for freestanding installation only.
• For freestanding installation, 6” of space at the back, 10-12” of space on each side, and unlimited
clearance at the top of the wine cooler are suggested to ensure proper air circulation to cool the
compressor and condenser. Do not place underneath a table, counter top, or anything of the sort as this
will not allow for proper air circulation.
• Do not slide the unit into place.
• Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To level the
wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
• For best performance it is recommended that you install the appliance in a location with an ambient
temperature between 60.8°- 89.6°F. If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected.
• Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
• Allow the appliance to cool down for 2-3 hours before placing wine bottles in the appliance.
OPERATING YOUR WINE COOLER
SETTING A TEMPERATURE
The temperature can be set from 41°F to 68°F.
1. Repeatedly press !/" to select the required temperature.
• Each time you press !/" the temperature will be increased or decreased by 1°F.
2. The temperature selected will flash on the display for approximately 5 seconds, then the display will
return to the current actual temperature of the internal cabinet.
• The current actual temperature will vary depending on the quantity of bottles stored and how
often the door is opened.
• To view the set temperature, press !/", the set temperature will flash on the display for
approximately 5 seconds.
Interior light
Press light button to turn the interior light on or off.
The interior light will automatically turn off after approximately 10 minutes if you leave the light on.
Operating Noises
Normal noises
• Motors are running.
• Refrigerant is flowing through the tubing.
3. Please press and hold the up and down arrow buttons for approximately 5-8 seconds,
you may or may not hear a beep.
4. Either way, after 8 seconds, release the buttons, and then hold down the “F/C” button for
another 5 seconds; the readout should change.
Loading ...
Loading ...
Loading ...