Loading ...
Loading ...
Loading ...
10
3. Select a place where a water supply can be easily
connected for the automatic icemaker.
NOTE: The water pressure must be between 20 and
120 psi (138–827 kPa) on models without a water
oOWHUDQGEHWZHHQDQGSVLN3D
4. Too small of a distance from adjacent items may
result in lowered freezing capability and increased
electricity consumption charges. Allow at leDVW
LQFKHVFPLQIront of the refrigerator to open the
doors.
INSTALLATION
The refrigerator should always be plugged into its own
individual properly grounded electrical outlet rated for 115
Volts, Hz, AC only, and fused at 15 amperes (minimum).
This provides the best performance and also prevents
overloading house wiring circuits which could cause a
hazard from overheated wires. It is recommended that a
separate circuit serving only this appliance be provided.
1. To avoid noise and vibration, the unit must be
leveled and installed on a solidly constructed poor. If
required, adjust the leveling legs to compensate for
unevenness of the
higher than the rear to aid in door closing. Leveling
legs can be turned easily by tipping the cabinet
slightly. Turn the leveling legs counterclockwise to raise
the unit or clockwise to lower it. (See LEVELING AND
DOOR ALIGNMENT.)
NOTE: Installing on carpeting, soft tile surfaces,
a platform or weakly supported structure is not
recommended.
2. Install this appliance in an area where the temperature
is betweHQ£)£&DQG£)£&,IWKH
temperature around the appliance is too low or high,
ected.
REFRIGERATOR INSTALLATION
Shock Hazard:
To reduce the risk of electric shock, do not install the
refrigerator in a wet or damp area.
WARNING
2” (5.08 cm)
2” (5.08 cm)
2” (5.08 cm)
2” (5.08 cm)
WARNING
Be careful when you work with the hinge, stopper, etc.
You may be injured.
To avoid risk of injury or electrical shock, do not put
hands or metal objects into the air vents or bottom
opening of the refrigerator.
Loading ...
Loading ...
Loading ...