Loading ...
Loading ...
Loading ...
8
INSTALLATION
To install the casters:
1. Move freezer to a work area that
provides sucient clearance on all
4 sides to allow easy handling and
access to the freezer.
2. Cover the floor area behind the
freezer with a protective material to
prevent damage while it is resting on
its back during the caster installation.
3. Remove the adjustable leveling legs
already installed on the freezer by
unscrewing counterclockwise, as they
are not required when using casters.
4. Remove casters and screws from
the caster kit. The Part A casters are
installed on the right front and rear
compressor side of the unit. The
Part B casters are installed on the
left front and rear of the unit (with
brake lever facing outside). Align the
caster holes with the corresponding
screw holes in the mounting loca-
tions. See Figure 1.
Figure 1
Part A
Part A
Part B
Part B
Left Side
Right Side
Bottom View
of Freezer
Front
Rear
Compressor Side
5. After casters are installed, with the
help of an assistant, carefully lift
and rotate the freezer to its upright
position. Move the freezer to the
desired location, and engage brakes
on the 2 left casters.
6. Wait a minimum of 2 hours before
connecting the freezer to an AC
power source. Avoid using a Ground
Fault Circuit Interrupter (GFCI)
outlet. Do not use an extension cord.
7. Load the freezer after the desired
operating temperature is reached.
CAUTION
Two or more people are required to rotate
and tilt the freezer on its back, allowing
accessibility to all sides.
WARNING
Casters with brakes are to stop chest
freezer movement on level ground only.
They are not intended to prevent move-
ment on an uneven or sloping floor.
Cleaning
• Wash any removable parts of the
freezer interior and exterior with mild
detergent and warm water. Wipe dry.
DO NOT USE HARSH CLEANERS ON
THESE SURFACES.
• Do not use razor blades or other
sharp instruments which can scratch
the freezer surface when removing
adhesive labels. Any glue left from
the tape can be removed with a mix-
ture of warm water and mild deter-
gent or the residue can be touched
with the sticky side of tape already
removed. DO NOT REMOVE THE
SERIAL PLATE.
Loading ...
Loading ...
Loading ...