EHG645SA User Manual

Loading ...

1. The bench cutout should be made as per cutout

dimensions in Table 2 and Figure 6.

2. Adjacent walls, cupboards and protection for

combustible materials: Ensure that the appliance is

installed in accordance with clauses 6.2.5 and 6.10.1.1

ofAS/NZS5601.1,orclauses6.9.1and6.9.5ofAS/

NZS 5601.2 with regard to clearances to combustible

surfacesandmaterials,andclearancestorangehoods

and exhaust fans.

To ensure clearances of 200mm from burners to

vertical combustible surfaces observe the minimum

distance requirements shown in Figure 7.

Clearances to combustible surfaces may be reduced

if combustible surfaces are protected in accordance

withclause6.10.1.2ofAS/NZS5601.1,orclause6.9.2

of AS/NZS 5601.2.

3. Barrier: A barrier must be installed to prevent

accidentalcontactwiththecooktopbase,wherethe

base of the cooktop is accessible from below (i.e.

Insideacupboard,etc.).Animpressionhasbeen

incorporated into the base to ensure a minimum

clearance of 15mm is maintained between the base

and the barrier. This barrier may be made of any non-

combustible,rigidmaterial.

Note: An alternative to the above is to purchase a

barrier shield from Electrolux spare parts (P/No. ACC

072)whichcanbetteddirectlytotheunderside

of the product. This shield protects the user from

accidently touching certain areas of the product.

Barrier protection is not necessary if the product

is installed above an underbench oven or similar

appliance and/or if the cupboard construction is such

that the underside of the cooktop is not accessible.

INSTALLATION PROCEDURE

4. A FOAM SEAL has been provided and is to be applied

along the perimeter of the hob.

5. Fit the pull down clamps supplied to ensure that the

cooktop cannot move after installation.

WARNING!

Failuretoxthecooktoptothebenchcouldresultin

loosening of the gas connection through movement of the

cooktop and a gas leak may result.

Four clamps and screws are supplied with 4-burner

models and six clamps and screws are supplied with

5-burner models. Fit the clamps as shown in Figure 8. No

clampsareneededformodelEHG313BAasitisttedwith

spring clips on the sides which locate on the inner edge of

the bench cutout.

Whenbenchtopsarelessthan33mminthickness,itmay

benecessarytotaspacerbetweenthebenchtopand

eachclamptoensureclampscanbetightenedsufciently.

Figure 7a – EHG313BA

Combustible surface

106106

Loading ...

User Manual - Page 18