Loading ...
Loading ...
Loading ...
35
Replacing Interior Oven Lights
CAUTION: DISCONNECT THE ELECTRIC POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BEFORE REPLACING BULB.
1. Unscrew glass light cover.
2. Use an oven mitt during bulb
removal to protect your hand in
case the bulb breaks.
3. Replace the bulb with a 120 volt,
40-watt appliance bulb.
4. Replace the light cover
5. Reconnect power at the main fuse
or circuit breaker.
Power Failure
If power failure occurs, the electric ignitors will not work. The range
surface burners can still be used, but only when the burners are lit
manually with a match. The griddle cannot be used at all. Do not attempt
to operate the oven. Make sure the oven control is in the “OFF” position.
Due to safety considerations and the possibility of personal injury in
attempting to light and extinguish the burner, the grill should, under no
circumstances, be used during a power failure. The grill burner control
should always remain in the “OFF” position during a power failure.
Momentary power failure can occur unnoticed. The range is affected only
when the power is interrupted. When it comes back on, the range will
function properly without any adjustments. A “brown-out” may or may
not affect range operation, depending on how severe the power loss is.
34
Oven Racks
Clean with detergent and hot water. Stubborn spots can be scoured
with a soap-filled steel wool pad.
Broiler
There is no special care required for the infrared broiler. It is designed as
self-contained unit, and no adjustments or cleaning are possible. Do not
attempt to clean it. Its own operation burns off any impurities which may
condense on it. Clean the broiler pan and grid after each use with
detergent and hot water. For stubborn spots, use a soap-filled steel wool
pad. The broiler pan and grid is also dishwasher safe.
Brass Parts
CAUTION: All brass special ordered parts are coated with an epoxy
coating. DO NOT USE BRASS OR ABRASIVE CLEANERS ON THE BRASS
OPTION PARTS. All brass parts should be wiped regularly with hot soapy
water.
Stainless Steel Parts
All stainless steel parts should be wiped regularly with hot, soapy water
at the end of each cooling period and with liquid stainless steel cleaner
when soapy water will not do the job. Do not use steel wool, abrasive
cloths, abrasive cleaners, or powders. If necessary to scrape stainless
steel to remove encrusted materials, soak the area with hot towels to
loosen the material, then use a wooden or nylon spatula or scraper. Do
not use a metal knife, spatula, or any other metal tool to scrape stainless
steel. For occasional heavy cleaning use, a cleaner such as Liquid Zud
can be used according to package directions. Do not permit citrus or
tomato juice to remain on stainless steel surface, as citric acid will
permanently discolor stainless steel. Wipe up any spills immediately.
Glass Surface
Clean with detergent and warm water. Glass cleaner can be used to
remove fingerprints. If using glass cleaner ammonia, make sure that it
does not run down on exterior door surface.
Wok Cast Iron Burner (If applicable)
For proper lighting and performance of the burner, keep the electric
igniter and burner ports clean. It is necessary to clean these only when
the flame does not burn blue completely around all rings of the burner,
when there is a severe spillover or when the burner does not light, even
though the electric spark igniter sparks. Clean the burner by scraping off
burned on food soil. Use a wire, a straightened paper clip, or needle to
clean the ports. Do not use a toothpick; it could break off in the port. Be
sure the venturi tube remains dry.
Burner
ports
Venturi tube
Orifice
Loading ...
Loading ...