Loading ...
Loading ...
Loading ...
Step 7: Attach Clamp Top (2) to clamp bottom (3) using the two long Allen
Bolts (1)
Step 8: Make sure the clamp is tightened all the way so there is no movement
Step 9: The swivel clamp allows you to rotate the speaker any direction you
may want. Loosen the allen locking bolt (19) and rotate the speaker to the
direction you like. Then tighten the bolt to lock it in place.
Step 10: The swivel clamp also allows you to remove the speaker from the
tower in seconds. Loosen the allen locking bolt (19) and remove the
detachment fork (17). Once removed, the speaker will disconnect from the
clamp. The clamp remains on the tower. To reinstall, line up the male speaker
plug (7) so that it is centered and insert the speaker by plugging the connector
together and reinstalling the detachment fork.
Cast Mount Tower Version using the TC3-S clamp for quick disconnect
and swivel function.
Step 1: Attach Male Connector (10) from clamp base to Female Connector (11)
Step 2: Push connector into center hole of speaker as you place clamp base
onto the speaker housing. Insert 4 bare wires down into this hole as well. These
wires are only used if you are adding the LED speaker rings. (please see LED
speaker install instructions for LED install) Please make sure the grommet (12)
is seated properly.
Step 3: Attach two short Allen Bolts (16) through the clamp base and tighten
into the housing. Please make sure these are tight. It is also recommend to use
a Blue Loctite on these bolts.
Step 4: Clamp Bottom (3) and Detachment Plate (5) are already connected
together. Remove allen bolts (6) that hold the detachment plate (5) to the clamp
bottom (3). Clamp Top (2) and Clamp Bottom (3) will not be used for a cast
tower mount.
Loading ...
Loading ...
Loading ...