Loading ...
Loading ...
Loading ...
39+, -2) ;-8', %'/-2+
%8)6-%0 7%2(-2+ 7%2(-2+ 7)88-2+ 4%(
!33(7 6-87->) 6-87->)
Softwoods 40/60 240 5-6 extra soft/soft
Hardwoods 40/60 180/240 5-6 soft
Veneers 240 320/400 5 extra soft/soft
)8%07
Steel 80/180 400 5 hard
Stainless 120 240 5 soft
Aluminum 80 240/400 4-5 soft
Rust spots 40 120 6 soft
=28,)8-' 4%-28
Sanding 180 400 4-5 soft
Scratches 120 220 3-4 hard
Stripping 40/60 80/120 5-6 soft
'6=0-' 4%-28
Sanding 180 320/400 4-5 soft
Scratches 120 240 4-5 hard
Stripping 40/60 80/120 2-3 soft
0%78-'7
PC/polystyrene 120 240 3-5 extra soft/soft
Thermoplastics 60 180 1-3 soft
Glass fiber reinforced plastics 80/120 240/400 1-3 soft/hard
30-(96*%')7 120 180/400 4-6 soft
!
Your tool is equipped with a mode selector
switch which allows you change the removal
performance of your sander.
To change operating modes, press mode
selector release button and turn switch until
you hear it latch near desired operating
symbol.
To prevent personal injury.
Do not change the mode
selector switch while the sander is in
operation.
4)6%8-2+3()
This operating mode is
recommended for fast material
removal on very rough, insensitive surfaces
as well as for buffing.
4)6%8-2+3()
This operatng mode is
recommended for sensitive
surfaces as well as for fine polishing.
#
The internal electronic feedback system
provides a "soft start", which will reduce the
stresses that occur from a high torque start.
The system also helps to keep the no load
speed virtually constant between no-load
and load conditions.
!
Your sander is also equipped with a variable
speed dial. The sander's orbital pad speed can
be preset from zero to maximum nameplate
OPM by rotating the dial in the housing. The
dial may be set on or between any of six
positions (1=low through 6=high).
The following table may be used as a general
guide for abrasive and backing pad selection,
but the best results will be obtained by sanding
a test sample of the workpiece first.
-8-
!
WARNING
BM 2609932224 07-09:BM 2609932224 07-09 7/30/09 8:22 AM Page 8
Loading ...
Loading ...
Loading ...