Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/87871327-11060096990/bga.png)
DRYER DIMENSIONS
Most installations will require at least
5-inch clearance behind the dryer for the
dryer vent.
Location must be large enough to fully
open dryer door.
283/8 'l
RECESSED AREA/CLOSET
INSTALLATION INSTRUCTIONS
Check governing codes and ordinances.
This dryer may be installed in a recessed
area or closet.
The dryer must not be installed where it
can be exposed to water and/or weather.
• Proper operation of dryer cycles
requires temperatures above 45°F (at
lower temperatures, the dryer may not
shut off at the end of automatic cycles
and drying times will be extended).
• Check code requirements. Some
codes limit or do not permit installation
of clothes dryers in garages, closets,
mobile homes, or sleeping quarters.
Contact your local building inspector.
WARNING: To reduce the risk of
fire, this appliance MUST BE
EXHAUSTED OUTDOORS.
NOTE: No fuel-burning appliances may
be installed in the same closet as a dryer.
10
-1--
18"
÷
*1"--'_
FrontView
(DoorNotShown)
MBNIMUM iNSTALLATION SPACING
**48sq.in.
minimum-
ventilation
area
**24sq.in.
minimum-
ventilation
area
_- **.51/2"
3"
3"
FrontView
(DoorWithVent)
* Additional clearances lor wall, doorand floor moldings may be required. 0" clearance
isacceptable but notrecommended.
** Openingis minimum lor closet door.Louvered doorwith equivalent air
openings is acceptable.
*** Additional spaoe isneeded when external exhaust elbow isused. Can be0" clearance
when houseexhausting is lined up directlywith dryer exhaust.
* In the above illustration, the installation required. Louvered doors with equivalent
spacing is in inches and is the minimum air openings in top and bottom are
allowable, acceptable.
* Additional spacing should be considered • Al! installations must be exhausted
for ease of installation and servicing, outside. Use at least the minimum
* If closet door is installed, the minimum air dimensions indicated.
openings in top and bottom are
Loading ...
Loading ...
Loading ...