Loading ...
Loading ...
Loading ...
11
It is recommended that you install the appliance in a place where the ambient temperature is
between 72º and 78ºF (23º to 26ºC). If the ambient temperature is above or below the recommended
temperatures, the performance of the unit may be affected. For example, placing your unit in
extremely cold or hot conditions may cause interior temperatures to fluctuate. The range of 36º to
43ºF (2º to 6ºC) may not be reached.
Control Panel
ON/OFF Power
• To turn the appliance off, press and hold the key for 5 seconds until the temperature display
goes out.
• To turn the appliance on, press and hold the key for 1 second until the temperature display
lights up.
NOTE: Pressing this key once can switch off the audible alarm when the alarm is on.
Light
Turns the interior light ON and OFF.
Up
Used to increase (warm) the set temperature by 1°C/1ºF.
Down
Used to decrease (cool) the set temperature by 1°C/1ºF.
ºF/ºC Selector
Select the temperature display setting in Fahrenheit or Celsius degrees. To change the temperature
from Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the LIGHT key for 5
seconds.
Setting the Temperature Control
• You can set the temperature by touching the UP and DOWN symbols. When you push the two
buttons for the first time, the LED readout will show the original temperature set previously. (The
temperature preset at the factory is 38°F or 3°C.)
• The temperature you are setting will increase by one degree each time you touch the UP
symbol, and will decrease by one degree each time you touch the DOWN symbol.
• The range of the temperature control is from 36°F to 43°F.
• To view the set temperature at any time, touch the UP or DOWN symbol. The set temperature
will flash in the display window for 5 seconds. After 5 seconds, the temperature inside the unit
will reappear in the display window.
NOTES:
• If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
• When you use the unit for the first time or restart the unit after it has been shut off for a
long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and is due to the length of the
activation time. There should not be a problem once the unit has been running for a few
hours.
Loading ...
Loading ...
Loading ...