Loading ...
Loading ...
Loading ...
IMPORTANT:
• Do not grasp console to move compactor.
• Begin in the room where the compactor will be
located.
1. Remove compactor from shipping carton. Remove
all protective packaging materials such as tape and
shipping pads. Remove waxy residue caused by pro-
tective shipping material with a mild solution of liquid
household cleaner and water.
2. Check that power supply cord is attached to the cord
clip on the rear of the compactor.
cord
clip
i
3. Place two corner posts from carton on floor near com-
pactor. Open compactor drawer and remove any ship-
ping materials or other items shipped in the drawer. Do
not remove the compactor bag (if installed). Grasp the
handle and raise the front of drawer until it clears the
drawer stops. Grasp sides of drawer and lift drawer out
of compactor. Place the drawer on the two corner
posts.
4. Place the other two corner posts on the floor to the
side of the compactor. Grasp the sides of the com-
pactor cabinet and put compactor on its side on top of
the corner posts. Remove the shipping base from the
bottom of compactor.
leveling legs
Freestanding and Undercounter Installation
NOTE: Proper installation is your responsibility. Make
sure you have everything necessary for correct installa-
tion. It is the personal responsibility and obligation of the
customer to contact a qualified installer to assure that
electrical installation meets all national and local codes
and ordinances.
Tools and materials needed for installation:
Level
Pliers
Scissors
Phillips screwdriver
Flat-Blade screwdriver
Utility knife
Measuring tape
_6" (8 mm)-Box-end wrench
Gloves
IMPORTANT:
• Do not grasp console to move compactor.
• Slide compactor onto cardboard or hardboard
before moving compactor across floor to prevent
damaging floor covering.
• Do not allow the rear frame of the compactor to
touch the floor covering when lifting or moving
compactor.
Freestanding installation:
1. Use pliers to lower leveling legs away from cabinet.
Place level inside on the floor of the cabinet. Check
that the compactor is level from front to back and side
to side. Adjust the leveling legs until the compactor is
level.
2. Move the compactor close to itsfinal position. Plug
the power supply cord into a 3-prong grounded outlet.
3. Carefully move compactor into itsfinal position.
Check that compactor is still level. Repeat step 1
if necessary.
4. Grasp sides of compactor drawer and place bottom
of drawer into tracks. Lift at the handle so drawer will
go over drawer stops. Close drawer. Check if drawer
opens freely. If the toe plate rubs against floor, see
"Adjusting the Toe Plate" for further instructions.
Loading ...
Loading ...
Loading ...