Loading ...
Loading ...
Loading ...
OPERATION OF WIRELESS REMOTE CONTROLLER
16
NOTE: During this procedure, if no button is pressed within 10 seconds, remote
controller will automatically exit the sleep curve setting and resume original display.
If ON/OFF, MODE, TIMER, SLEEP, COOLING or HEATING button is pressed during the
setting or inquiry procedure, remote controller will also exit the sleep curve setting.
Sleep function will be disabled if the air conditioner is restarted after power failure;
Sleep function can not be set in AUTO mode.
DIY MODE - SLEEP 3
You will be required to enter eight (8) room setpoint values for eight (8) hours of run time. The last
room setpoint value will be maintained until sleep mode is cancelled.
In Sleep Mode 3, press "Prog" button to enter setup mode. The remote controller will display
“1:00” in the time location. Use the “+” and “-“ buttons to select the desired room setpoint for
the first hour of run time. Then press the “Prog” button to save the setpoint.
The remote controller time display will change to “2:00.” Once again, use the “+” and “-“ buttons
to select the desired room setpoint for the second hour of run time, and press the “Prog” button to
again save the setpoint.
Repeat this sequence for the eight (8) room setpoint values. After all eight (8) values have been
entered, the remote controller will automatically revert to standard time and temperature display,
and the Sleep 3 Mode will begin.
At any time, you may press the “ON/OFF," " Mode," " Timer," "Sleep” or “Turbo" buttons to cancel
the Sleep 3 Mode.
Loading ...
Loading ...
Loading ...