Loading ...
Loading ...
Loading ...
_[.,."_"]::1_v_I:)_"d
,_ WARNING: AVOID INJURY. Readand understand the entire Safety
section before proceeding.
Tools Required
Adjustable wrench
9/16" wrench
Petroleum jelly or dielectric grease.
Unpack Unit
Remove unit and all other components from
the shipping container. Engage transmission
bypass lever (see MOVING UNIT
MANUALLYon page 14). Push unit from
container onto a level surface. Disengage
transmission bypass lever.
Connect Battery
See Battery Removal and Installation on
page 21 and perform steps 2 and 3 in the
installation section.
Place Unit in Operating Position
(figure 3):
NOTE: The unit is shipped with the seat
positioned as far back as possible.
1. Tip seat forward and adjust the seat as
needed (see ADJUSTING STEERING
LEVERS on page 22).
2. Remove eccentric spacers and rotate
steering levers to the operating position.
reinstall spacers. Do not tighten.
3. Adjust steering levers (see ADJUSTING
STEERING LEVERS on page 22).
Figure 3
1. Seat
2. Steering
Lever
3. Eccentric
Spacer
4. Handlebar
Brackets
Place Discharge Chute in Operating
Position
,_ WARNING: Do not operate
mower unless the discharge chute
is in the operating position.
Prior to operating the unit, remove the
discharge chute from the transport position
and place the discharge chute in the
operating position (figure 4).
Discharge Chute in Transport Position
Discharge Chute in Operating Position
Figure 4
GB - 10
Loading ...
Loading ...
Loading ...