MFL68005529
www.kenmore.com
Sears Canada Inc.
Toronto, Ontario, Canada M5B 2C3
www.sears.ca
All safety messages will follow the safety alert symbol and the word WARNING.
This word means:
29 in. (W) X 32
7
/8 in. (D) X 40
3
/4 in. (H), 58
11
/16 in. (D, with door open)
73.7 cm (W) X 83.5 cm (D) X 103.5 cm (H), 149 cm (D, with door open)
25
13
/
16
in.
(65.5 cm)
32
7
/
8
in.
(83.5 cm)
58
11
/
16
in.
(149 cm)
Allow at least 25
13
/16 in. (65.5 cm) in front of
the washer to open the door.
29
in.
(73.7 cm)
All Cold Rinses
3
one hour
3
All Cold Rinses
For best performance, load clothes as shown.
- Load clothes loosely, and do not overfill the drum.
Clothes need room to circulate in order to get clean.
- Do not press down on items while stacking them in the drum.
1
3
2
4
All Cold Rinses
3
one
three
nineteen
hour,
3
three
three seconds.
three seconds.
PRE WASH
Turn ON the washer and press and hold the ACCELA
WASH button for three seconds. Selecting any other
cycle after CLEAN WASHER has been selected will
cause the CLEAN WASHER cycle to be cancelled.
WARNING:
Certain internal parts are intentionally not grounded and may present a risk of electric shock
only during servicing. Service personnel - Do not contact the following parts while the appliance is energized:
pump, valve, motor, control board.
If you experience problems with your washer, in the
U.S.A. call 1-844-553-6667, and in Canada call
1-800-469-4663.
First, call 1-844-553-6667 (U.S.A.) or 1-800-469-4663 (Canada).
If the washing machine detects too many
suds, it displays this error code and adds
a Suds Reducing cycle. This adds about
two hours to the cycle time.
If too many suds are detected during
spinning, the washing machine stops to
help prevent leaking.
Make sure the drain hose is free of clogs, kinks, etc., and is
not pinched behind or under the washer.
Clean the drain pump filter. See Maintenance in the Care
and Cleaning section.
Adjust or repair drain. Maximum drain height is 96 inches.
Drain hose is kinked, pinched, or clogged.
The drain pump filter is clogged.
Drain discharge is more than 96 inches
above bottom of washer.
Make sure that the water faucets are fully open.
Make sure the hoses are not kinked or pinched. Be careful
when moving the washer during cleaning and maintenance.
Clean the inlet filters. See Maintenance in the Care and
Cleaning section.
Check another faucet in the house to make sure that
household water pressure is adequate and flow is not
restricted.
Hoses designed to limit leaks can trip falsely and prevent
the washer from filling. The use of leak limiting hoses is not
recommended.
Water supply faucets are not open fully.
Water line hoses are kinked, pinched,
or crushed.
Water inlet filters are clogged.
Water supply pressure to faucet or
house is too low.
Water supply connected with leak-
limiting hoses.
Make sure that the door is closed properly and press the
START/PAUSE button. After starting a cycle, it may take a
few moments before the drum begins to turn or spin. The
washer will not operate unless the door is locked.
If the door is closed and locked and the open door error
message is displayed, call fro service.
The door is not closed properly.
Add 1 or 2 similar items to help balance the load.
The washer has an imbalance detection and correction
system. If individual heavy articles are loaded (bath mat,
bath robe, etc.) and the imbalance is too great, the wather
will make several attempts to restart the spin cycle. If an
imbalance is still detected, the washer will stop and the
error code will display.
Load is too small.
Load is out of balance.
Unplug the washer and wait 60 seconds. Reconnect power
and try again. If the error reappears, call for service.
Control error.
Close the water faucets, unplug the washer, and call for
service.
Water level is too high due to a faulty
water valve.
Close the water faucets, unplug the washer, and call for
service.
The water level sensor is not working
correctly.
Allow the washer to stand for 30 minutes and then restart
the cycle. If the LE error code persists, call for service.
A motor error has occurred.
If the power to the washer has been interrupted during a
cycle, the PF error code will display the next time the
washer is turned ON. This will alert you to the fact that the
previous cycle may not have been completed. Select any
cycle to clear the error code and use the washer.
Do not add more than the manufacturer's recommended
To remove suds, turn the washer off and on, then run the
Rinse & Spin cycle.
amount of detergent.
A power failure has occurred.
KENMORE ELITE LIMITED WARRANTY
WITH PROOF OF SALE the following warranty coverage applies when this appliance is correctly installed,
operated and maintained according to all supplied instructions.
One Year on Appliance
FOR ONE YEAR from the date of sale this appliance is warranted against defects in material or workmanship.
A defective appliance will receive free repair. If the appliance cannot be repaired it will be replaced free of
charge.
Lifetime on Washer Drive Motor
FOR AS LONG AS IT IS USED from the date of sale, a free replacement will be supplied for a defective washer
Lifetime warranty covers only the washer drive motor, and does not apply to any other related component or
For warranty coverage details to obtain free repair, visit the web page:
www.kenmore.com/warranty
All warranty coverage applies for only 90 DAYS from the sale date if this appliance is ever used for other than
private household purposes.
This warranty covers ONLY defects in material and workmanship, and will NOT pay for:
1.
in base light bulbs.
2. A service technician to clean or maintain this appliance, or to instruct the user in correct appliance
installation, operation and maintenance.
3. Service calls to correct appliance installation not performed by Sears authorized service agents, or to repair
problems with house fuses, circuit breakers, house wiring, and plumbing or gas supply systems resulting from
such installation.
4. Damage to or failure of this appliance resulting from installation not performed by Sears authorized service
agents, including installation that was not in accord with electrical, gas or plumbing codes.
5. Damage to or failure of this appliance, including discoloration or surface rust, if it is not correctly operated
and maintained according to all supplied instructions.
6. Damage to or failure of this appliance, including discoloration or surface rust, resulting from accident,
alteration, abuse, misuse or use for other than its intended purpose.
7. Damage to or failure of this appliance, including discoloration or surface rust, caused by the use of
detergents, cleaners, chemicals or utensils other than those recommended in all instructions supplied with the
product.
9. Service to an appliance if the model and serial plate is missing, altered, or cannot easily be determined to
Disclaimer of implied warranties; limitation of remedies
Customer’s sole and exclusive remedy under this limited warranty shall be product repair or replacement as
are limited to one year on the appliance and for as long as used on the washer drive motor, or the shortest
period allowed by law. Seller shall not be liable for incidental or consequential damages. Some states and
provinces do not allow the exclusion or limitation of incidental or consequential damages, or limitation on the
you.
This warranty applies only while this appliance is used in the United States.
Kenmore
®
Customer Care Hotline
To schedule in-home repair service
or order replacement parts
Para pedir servicio de reparación
a domicilio, y ordenar piezas
1-844-553-6667
www. kenmore. com
®
