Loading ...
Loading ...
Loading ...
1. Place the SPIRIT
TM
Sparkling Water Maker on a flat sturdy surface in an upright
position. Remove the back cover by pressing on the top of the back cover and
pulling it away from the body of the Sparkling Water Maker. Set the back cover
aside.
2. Remove seal and cap from the SodaStream CO
2
cylinder. Tip the Sparkling Water
Maker forward and insert the cylinder through the hole in the base and upward to
the cylinder holder at the top of the Sparkling Water Maker.
3. Return the Sparkling Water Maker to the upright position with the cylinder valve
inside the cylinder holder. Screw the cylinder valve thread into the cylinder holder
and twist. Hand-tighten only; DO NOT use tools.
4. Reinstall the back cover by fitting the upright tab at the bottom of the back cover
into the slot at the rear of the base of the Sparkling Water Maker and pushing the
cover into place onto the back of the Sparkling Water Maker. Now you are ready to
create the bubbles.
INSTALLING THE CO
2
CYLINDER INSTALLING THE CO
2
CYLINDER
Loading ...
Loading ...
Loading ...