Loading ...
Loading ...
Loading ...
8
1886
Installing the Bulbs and Glass
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs Remote CradleRemote
Install the included bulb
into the socket. When
necessary, replace with
bulb of same wattage.
To install the glass, rst
loosen the thumb screws.
Raise the glass to the
light xture. Tighten all
thumbscrews securely.
Tighten all three screws
securely by hand.
NOTE: Check to ensure
proper engagement.
Assembling the LIght Kit
Partially install two light kit assembly
screws, found in the
hardware
bag, halfway into the motor housing
as shown. It does not matter which
two screw holes you choose.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
2 of 6
Light Kit Screw
BAG
Install the three switch housing screws, found in
the
hardware bag. Tighten all three screws.
3 of 6
Light Kit Screw
BAG
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Insert the third screw,
found in the
hardware
bag, into place and then
tighten all three screws.
1 of 6
Light Kit Screw
BAG
ON
ON
T
urn
Po
w
e
r
Connect the single-pin connectors from
the LED assembly to the connectors from
the fan. Connect the white wires together.
Connect the blue and black wires together.
Lift the lower switch housing until its screw
holes are aligned with the screw holes in the
upper switch housing.
Loading ...
Loading ...
Loading ...