Loading ...
Loading ...
Loading ...
15
Helpful Tip: Remove all internal shipping material, drain hose,
installation kit, and handle (if included,) before laying on it’s back,
and do not remove lm on the door at this time.
Place cardboard under dishwasher until installed
in cabinet opening to avoid damaging oor covering.
Using two or more people, grasp sides of dishwasher door frame,
and place the dishwasher on its back.
Do not use the door panel as a worktable without rst covering
it with a towel to avoid scratching the door panel.
REMOVE ACCESS PANEL AND INSULATION
Using a 5/16" (7.9 mm) nut driver, remove the two screws
attaching access panels to dishwasher. Once the screws are
removed push the access panel toward the top of the product to
unhook it and then remove it.
On some models, a service connection wire with a 3-pin
connector is intentionally left unplugged and tucked behind the
access panel. This is provided for use by the service technician.
NOTE: Leave this wire unplugged and placed out of the way
when reinstalling the access panel.
DISCONNECT AND REMOVE DRIP TRAY
ASSEMBLY
10a.
Remove drip tray assembly
To remove the drip tray assembly, press the snap at each side
of the plastic tray in toward the center of the product and pull
toward yourself. Be sure not to pull too far or too hard as the oat
switch wire is still connected at this time.
10b. Remove float switch wire
To remove the oat switch wire, gently push the connector latch
tab (1) and then pull the connector (2) out of the housing. The
oat itself should not be removed from the tray.
NOTE: Do not reinstall drip tray until instructed.
8. Put the dishwasher on its back
9. Remove access panels
10. Remove
access
panel
1
2
Drip tray assembly
3-Pin Connector
9a. Remove access panels
Loading ...
Loading ...
Loading ...