Loading ...
1. Choose a location that avoids static and eases away from
splashing water. Find a clean, dry and smooth surface,
then wipe o the dust.
2. Slowly peel away the 3M adhesive backing and take it out
bit by bit.
3. Stick the light strip and press it down for 10-15 seconds.
Secure the controller with the adhesive pads. Do not move it
to other place after it is attached.
• NOT FOR EMERGENCY LIGHTING
• Not intended for recessed installation in ceilings, or sots.
• Only use the control provided with or specied by these
instructions to control this device.
• To prevent re danger, do not run cord behind walls, ceilings,
sots, or cabinets where it may be inaccessible for examination.
• Use only insulated staples or plastic ties to secure cords.
• The maximum distance to the receptacle is determined by the
length of adapter cord.
• Keep the device away from water, re, humidity or hot
environments.
• Do not attempt to disassemble, repair, or modify the device. If you
need service, please contact us.
• Do not use the device where wireless devices are not allowed.
• Do not use damaged charger or USB cable to charge the device.
• Do not use any other chargers than those recommended.
• Adapter shall be installed near the equipment and shall be easily
accessible.
4. Plug in the power adapter to power on your light strip.
Safety Notice
• Route and secure cords so that they will not be pinched or
damaged when the cabinet is pushed to the wall;
• Position the portable cabinet light with respect to the cabinet
so the lamp replacement markings are able to be read during
replacing;
• The National Electrical Code (NEC) does not permit cords to be
concealed where damage to insulation may go unnoticed. To
prevent re danger, do not run cord behind walls, ceilings,
sots, or cabinets where it may be inaccessible for
examination. Cords should be visually examined periodically
and immediately replaced when any damage is noted.
Support
For technical support, the user guide and other information,
please visit https://www.tapo.com/support/.
Install Your Light Strip