Loading ...
Loading ...
Loading ...
CHECK FOR DAMAGED OR
WORN PARTS
Contact Sears Service Center for re-
placement of damaged or worn parts.
• ON/STOP Switch - Ensure ON/STOP
switch functions properly by pushing
and releasing the switch. Make sure
engine stops. Wait 5 seconds before
attempting to restart unit to allow
switch to reset. Restart engine and
continue.
• Fuel Tank - Discontinue use of unit
if fuel tank shows signs of damage
or leaks.
• Debris Shield - Discontinue use of
unit if debris shield is damaged.
INSPECT AND CLEAN UNIT AND
LABELS
• After each use, inspect complete
unit for toose or damaged parts,
Clean the unit and labels using a
damp cloth with a mitd detergent.
• Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine per-
formance and increases fuel con-
sumption and harmful emissions. Al-
ways clean after every 5 hours of
operation.
1. Clean the cover and the area
around it to keep dirt from failing
into the carburetor chamber when
the cover is removed.
2. Remove parts by pressing tatch to
release air filter cover.
NOTE: To avoid creating a fire hazard
or producing harmful evaporative
emissions, do not clean filter in gaso-
line or other flammable solvent.
3. Wash the filter in soap and water,
4. Allow filter to dry.
5. Add a few drops of oil to the filter;
squeeze the filter to distribute oil.
6. Replace parts.
Button Air Filter
Air Filter Cover
INSPECT MUFFLER AND SPARK
ARRESTING SCREEN
_WARNING: The muffleron this
product contains chemicals known to
the State of California to cause cancer.
_WARNING: Muffler is very hot
during and after use. Do not touch the
muffler or allow combustible material
such as dry grass or fuel to do so.
As your unit is used, carbon deposits
build up on the muffler and spark ar-
resting screen. For normal homeown-
er use, however, the muffter and spark
arresting screen will not require any
service. After 50 hours of use, we rec-
ommend that your muffler be serviced
or repiaced by your Sears Service Cen-
ter.
REPLACE SPARK PLUG
Replace the spark plug each year to
ensure the engine starts easier and
runs better. Set spark plug gap at
0.025 inch (0.6 mm). Ignition timing is
fixed and
nonadjustable.
1. Twist, then pult off spark plug boot.
2. Remove spark plug from cylinder
and discard.
3. Replace with Champion RCJ-6Y
spark plug and tighten secureiy
with a 3/4 inch (t9 mm) socket
wrench.
4. Reinstall the spark plug boot.
LINE REPLACEMENT
1. Press the tabs on the side of the
trimmer head and remove cover
and spool,
.... _ Cover
Tab
__ Tap Button
2. Remove any remaining line.
3. Clean dirt and debris from alt
parts. Replace spool if it is worn or
damaged.
4. Replace with a pre-wound spool
(#71-85950), or replace line using a
15 feet (4.5 meters) length of 0.095
inch (2.4 mm) diameter Craftsman
brand line.
5. When installing new line on an ex-
isting spool, hold the spool as
shown in the illustration below.
16
Loading ...
Loading ...
Loading ...