Loading ...
Loading ...
Loading ...
re and (;leaning
Advanlium Oven
Co&top light/
night light
To replace the cooktop light/
night light, first disconnect tile
power at tile main fuse or circuit
breaker panel.
.
Remoxe tile screws flom tile
side of tile light comi)artment
coxer and lower the coxer until
it stops.
.
Be sure the bulb(s) to be replaced
are cool before removing. Break
tile adhesive seal by gently
unscrewing the bulb (s).
R@lace with 40-watt (max.) incangh<_cg_nt
bull).s. O, zt#r 1"_!7_02X425 3,f!om you, (;E
su[)plie_: High-irl, tensil_ 40-watt bulbs
(40S 11N/l), available in supoma,t'ets
a,ld ha'_lwa'_v .stor_<_',may a£o be u.sedjbr
roidacem_,nts.
4. Raise tile light coxer and replace
the screws. Connect electrical
power to the oxen.
Pu?usable vent
.filters
Tile metal filmrs trap grease released
by foods on tile cooktop. They also
prevent flames flom foods on tile
cooktop flom damaging the inside
of the oven.
For this reason, tile filters must
always be in place when tile hood
is used. Tile xent filters should be
cleaned once a month, or as needed.
Removing and
cleaning the
filters
To remove, slide them to tile side
using the tabs. Pull down and out.
To clean the vent filters, soak them
and then swish around in hot wamr
and detergent. Don't use ammonia
or ammonia products because
they will darken tile metal. Light
brushing carl be used to remove
embedded dirt.
Rinse, shake and let dry before
replacing.
To replace, slide tile filters into
the flame slots on tile side of each
opening. Press up and to the side
to lock into place.
39
Loading ...
Loading ...
Loading ...