INSTRUCTIONS FOR USE
1
GB
DIAGRAM OF THE APPLIANCE FIG. 1
A. Handle.
B. Safety lock (if provided).
C. Gasket.
D. Separator (if provided).
E. Defrost water drain plug.
F. Control panel.
G. Side motor cooling grille.
INSTALLATION
• Please refer to the chapter “BEFORE USING THE
APPLIANCE”.
• Unpack the appliance.
• Remove the 4 protection pieces inserted between lid
and appliance.
• Ensure that the defrosting water drainage plug (if provided)
is correctly positioned (4).
• For best operation of the appliance and in order to avoid
damage when the lid is opened, leave a space of at least
7cm from the rear wall and 7 cm at the sides.
• Fit the accessories (if provided).
• Clean the inside of the appliance before using it.
DIAGRAM OF THE CONTROL PANEL FIG. 2
1. Thermostat: it can be used to adjust the internal
temperature of the appliance.
2. Red LED (if provided): Indicates that the appliance
temperature is not suciently low.
3. Green LED (if provided): indicates that the appliance is on.
4. Yellow/orange illuminated button (if provided):
activates/deactivates the fast freeze function.
IMPORTANT: when using the product as a cooler please
check that the fast freeze function is not activated in order
to avoid bottle cracking.
The exact conguration of the controls may vary according
to the model.
Switching on the appliance
• The appliance is factory set for optimum freezer operation
at a temperature of -18°C.
• Plug in the appliance.
• The green LED lights up (if provided).
• Also the red LED (if provided) will switch on because the
temperature inside the appliance is not yet suciently low
for food storage. The red LED will normally switch o within
the rst six hours after the appliance is switched on.
• After connecting the appliance to the mains supply and
when the optimal temperature has been reached, ensure
that the fast freeze button is not pressed (the yellow LED, if
provided, is o ).
• Place food inside the product only when the red LED (if
provided) has switched o .
Note: As the seal is tight, the appliance lid cannot be
reopened immediately after closing. Wait a few minutes before
re-opening the lid of the appliance.
Note:This appliance features “skin condenser” technology:
the condensing unit is integrated into the walls of the freezer.
For this reason the side and front walls of the product may
become hot while the product is running. This is entirely
normal and also reduces the risk of condensation forming in
particularly critical environmental conditions (see paragraph
“Troubleshooting guide”).
Temperature Adjustment
Use the thermostat to select the ideal storage temperature.
This product could be used both as freezer and as cooler.
•
To use the product as freezer set thermostat in position
“freezer”. In this case the product must be used to store
frozen food, to freeze fresh food and to make ice.
Internal temperature could be set between -14°C and
-22°C (depending on the environmental conditions, this
range may vary slightly)
• To use the product as cooler set thermostat in position
“cooler”. In this case the product must be used to store fresh
food and beverages.
Internal temperature could be set between 0°C and
+6°C (depending on the environmental conditions, this
range may vary slightly)
• To turn o the product set thermostat in OFF position.
In this case the product is already connected to power
supply.
IMPORTANT: when using the product as a cooler please
check that the fast freeze function is not activated in order
to avoid bottle cracking.
WHEN THE APPLIANCE IS NOT IN USE
Disconnect the appliance from the mains power supply, then
empty, defrost (if necessary) and clean it. Leave the door
open, so that air can circulate inside the compartments. This
will prevent the formation of mould and bad odours and an
oxidation (blackening) of internal walls.
COOLER USE
Before switching from freezer use to cooler use please:
1. check that frozen food is not present inside the cavity to
avoid unwanted food defrosting.
2. defrost and clean the product to avoid water stagnation on
the bottom.
Note: In the case of high levels of humidity, it is possible that inside
the appliance condensation may form on both the walls and the
bottom of the compartment. This is absolutely natural and does not
jeopardise the operation of the appliance in any way.
Loading ...
Loading ...
Loading ...