Loading ...
Loading ...
Loading ...
4
Service/ Repair
Service Note
Use
Installation
Electrical Connection
Attention:
Keep ventilation openings clear of obstruction.
Ambient Temperature Range
+18℃ to + 43℃
·Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
This product should be serviced by an authorized
Service Center, and only genuine spare parts should
be used.
·Under no circumstances should you attempt to
repair the appliance yourself. Repairs carried out by
inexperienced persons may cause injury or more
serious malfunctioning. Refer to your local Service
Center, and always insist on genuine Hisense spare
parts.·
This appliance contains hydrocarbons in its cooling
unit; maintenance and recharging must therefore
only be carried out by authorized technicians.
This appliance employs Hydrocarbon Refrigerant
type R600a. It is hazardous for anyone other than
an Authorized Service Person to service this
appliance
·The beverage cabinet is designed to be used
specifically for the storage of beverage.
·Best performance is obtained with ambient
temperature as follows:
The class of your appliance is shown on its rating
plate.
Note: If the ambient temperature is higher or
lower than the above listed, the energy
consumption will be affected accordingly.
·Do not store flammable gas and liquid in the
appliance, because they may explode.
·Do not place wine directly against the rear wall
of compartment.
·The appliance manufacturer’s storage
recommendations should be strictly adhered to.
Refer to Using your appliance.
·The inner lining of the appliance has channels
through which the refrigerant passes. Should the
channels be punctured the unit could become
damaged beyond repair.
DO NOT USE SHARP INSTRUMENTS to scrape off
frost or ice. Frost may be removed by using a
frosting period.
Under no circumstances should solid ice be
forced off the liner. Solid ice should be allowed to
thaw by defrosting the appliance.
Important: For electrical connection carefully
follow the instructions given in specific paragraphs.
·Unpack the appliance and check if there is any
damage to it. Do not connect the appliance if it is
damaged. Report possible damage immediately to
the place of purchase. In this case retain all
packing materials.
·During normal operation, the compressor and/or
condenser at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be maintained as shown in the
instructions.
·Care must be taken to ensure that the appliance
does not stand on the electrical supply
cable.Important: if the power cord is damaged, it
must be replaced by a special cord or assembly
available from the manufacturer or its service
agent.
·Do not use extension cords or ungrounded (two
prong) adapters.
·If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to wait
at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
·There are working parts in this product which heat
up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible loss. See
installation instructions.
·Parts which heat up should not be exposed.
Wherever pos
sible the back of the product should
be near the wall.
1. The appliance requires a single phase 230V/50Hz
power supply. It has a power cord that has a 3-prong
grounding plug that minimizes the possibility
of electrical shock. This appliance must be grounded.
Do not remove the grounding prong or modify the
power plug.
2. Do not modify the power plug. The power plug
must be accessible when the appliance is installed.
3. The appliance should not be turned off with a
switch or other device.
4. Make sure that the plug is not squashed or
damaged. Otherwise, it may cause short circuit,
electric shock or overheat and even cause a fire.
5. Do no insert the power plug if the socket is loose,
there is a risk of electric shock or fire.
Loading ...
Loading ...
Loading ...