Loading ...
Loading ...
2EN
WIRING
HIGH LEVEL INPUT WIRING
The high level input(s) should only be used when your receiver lacks RCA outputs. If the RCA
outputs are not present, connect the speaker outputs from the receiver to the high level input
connector of the amplifier. Be sure to observe polarity to avoid audio phase problems.
LOW LEVEL INPUT WIRING
Low-level (RCA) input wiring is preferred for best audio performance. Most trunk and under-seat
installations will require a 6-12 feet RCA cable. Always use a high quality cable.
POWER CONNECTIONS
Connect the ground terminal to the closest point on the chassis of the vehicle. Use 8 gauge (or
heavier) wire to connect the ground cable.
Connect the remote terminal to the remote output of head unit using 16 gauge ( or heavier )
wire.
Connect an empty fuse holder within 16" (40 cm) of the car battery, and run 8 gauge (or heavier)
cable from this fuse to the amplifier location. Then connect the fuse holder to the "BATT+" (+12V)
connection on the subwoofer rear panel.
NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier
at the same time!
NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier
at the same time!
Fig.1
Fig.2
Loading ...
Loading ...
Loading ...