AGA AMCTTDWWHT 24 Inch Fully Integrated BuiltIn Dishwasher w

User Manual - Page 18

For AMCTTDWWHT.

PDF File Manual, 64 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
18
SOLUTIONS TO COMMON PROBLEMS
Winterizing
A dishwasher left in an unheated place should be protected
from freezing. Have a qualied person do the following.
To Disconnect Service:
1. Turn off electrical power to the dishwasher at the sup-
ply source by removing fuses or tripping circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect water line
from the inlet valve and drain into pan.
4. Disconnect drain line from pump and drain water into
pan.
To Restore Service:
1. Reconnect the water, drain, and electrical power sup-
ply.
2. Turn on water and electrical power supply
3. Fill detergent cup and run the dishwasher through
HEAVY WASH cycle.
4. Check connections to make sure they do not leak.
NOTE
!
CAUTION
Freezing temperatures may cause water lines to rupture.
Be sure all supply lines to and circulating lines within your
dishwasher are protected. Failure to do so could result in
property damage.
See Installation Instructions for more details.
Before calling for service, review this list. If may save
you both time and expense. This list includes common
experiences that are not the result of defective work-
manship or material in your dishwasher.
Food Soils Left on Dishes
Choose another cycle for longer washing time.
Choose the Hi-Temp Wash option.
Check rack loading section for proper loading avoid
nesting items.
Home water pressure may be too low-should be 20 to
120 pounds per square inch (psi).
Check incoming water temperature. It should be about
120°F (49°C). (See Factors Affecting Performance.)
Check water hardness. For extremely hard water, it
may be necessary to install a water softener. (See
Detergent Chart).
Use Fresh Detergent.
Make sure items are not blocking the spray arms, pre-
venting them from rotating.
Dishes not Dry
Select heat dry option.
Make sure the rinse aid dispenser is lled.
Increase the discharge setting of rinse aid. (See Rinse
Aid).
Check the incoming water temperature. Be sure it is at
least 120°F (49°C).
Check for proper loading-avoid nesting items.
Plastic items may need to be towel dried.
Cups with a concave bottom will collect water. Load
them at the far left of the upper rack so they will be held
in a tilted position.
Loading ...
Loading ...
Loading ...