Loading ...
Loading ...
Loading ...
9 10
1. Measure the distance from the floor to the bottom of the Anti-Tip bracket
receptacle on the back of the appliance.
2. Position the two anti-tip brackets on the wall at the desired height plus 1/8˝ (0.32
cm). The brackets must be placed at 2 & 5/16” (6.0cm) from the side of the range.
The distance between the two brackets is 25 & 1/4 “(64.1 cm).
3. Secure the brackets to the wall with appropriate hardware.
4. Slide the range against the wall until the brackets are fully inserted into their
receptacles’ on the back of the range.
5. Check to see that the Anti-Tip device is installed properly. Then grasp the top rear
edge of the range and carefully attempt to tilt it forward. Verify that the Anti-Tip
device is engaged.
6. Or use the anti-tip device as one chain, and tighten up with fixed screw on the
wall. If the wall is not suitable for installation, then the chain shall be fixed to the
cabinet stucture.
7. The two sides of the chains are fixed on the wall or cabinet structure.
Installing the Anti-tip Stability device
Installing the Anti-Tip
Stability Device
A properly grounded and horizontally-mounted electrical receptacle type NEMA 14-
50R should be installed no higher than 3” above the floor, no less than 2” and not
more than 8” from the left side (facing product); refer to electrical connection section.
Gas
An agency-approved, properly-sized manual shut-off valve should be installed no
higher than 3” aboce the floor and no less than 2” and no more than 8” from the
right side (facing product).
To connect gas between shut-off valve and regulator, use agency-approved,
properly sized flexible or rigid pipe. Check all local code requirements.
Installation Adjacent to Kitchen Cabinets
The range may be installed directly adjacent to existing coutertop height cabinets
(36”) from the floor.
For the best look, the worktop should be level with the cabinet countertop. This can be
accomplished by raising the unit using the adjustment spindles on the legs.
ATTENTION: the range CANNOT be installed directly adjacent to kitchen walls, tall
cabinets, tall appliances, or other vertical surfaces above 36˝ high. The minimum
side clearance in such cases is 6”.
Wall cabinets with minimum side clearance must be installed 30˝ above the
countertop with coun-tertop height between 35.5” and 37.25”. The maximum depth
of wall cabinets above the range shall be 13”.
Installation Requirements
Loading ...
Loading ...
Loading ...