Summit FF711ESLLF2 19" Wide Refrigerator-Freezer

User Manual - Page 6

For FF711ESLLF2.

PDF File Manual, 12 pages, Read Online | Download pdf file

FF711ESLLF2 photo
Loading ...
Loading ...
Loading ...
6
INSTALLING YOUR REFRIGERATOR
This appliance is intended to be used in household or similar applications.
To use your appliance with the most efficiency and safety, select a suitable place installation
according to the following:
1. This appliance is designed for free-standing installation only, and
should not be recessed or built-in.
2. The appliance should be installed on a strong level floor or
counter. If the floor is not quite level, adjust the leveling feet.
3. A minimum of 3 inches of clearance must be provided between the
rear condenser and wall. Also, allow 2 inches of space on the
sides and 12 inches on the top. If another appliance, such as a
microwave, is placed on top, allow 4 inches of space above it.
Providing greater rear wall clearance when space allows in order
to improve air circulation is recommended.
4. Avoid any direct sunlight, heat, and moisture.
5. This appliance is equipped with a three-prong plug and is
grounded to eliminate electrical hazards. In order to make it
effective, the appliance must be plugged into a ground electrical
outlet.
6. Do not use an extension cord.
TEST RUN
Before using the refrigerator, clean it and make a test run to see if the following are completed. If
not, check the electricity supply. If the cause of trouble cannot be located, contact your Summit
dealer.
1. Plug the AC cord into an electrical outlet of 115 volt, 60Hz, set
FRIDGE CONTROL to "COLDEST", and let the refrigerator operate
for 10 minutes. Cold air should flow through the discharge outlet,
and the compressor motor should run smoothly with a soft hum.
2. When the COOL POWER button is pressed for at least three (3)
seconds, the OFF-LED light turns on, and the refrigerator stops
operating. Wait at least five (5) minutes, then press COOL POWER
button for at least three (3) seconds again. The OFF-LED turns off,
and the refrigerator resumes operation. Be sure to turn off COOL
POWER OFF mode. Otherwise, the refrigerator will not operate.
3. If the FRIDGE CONTROL button is set to "COLD" after running
refrigerator for more than 100 minutes, the compressor motor will
turn off.
ATTENTION:
If the unit is turned off or unplugged, YOU MUST ALLOW FIVE (5) MINUTES BEFORE
RESTARTING OR REPLUGGING THE UNIT. The unit may not start if you attempt to restart it in
less than (5) minutes.
Loading ...
Loading ...
Loading ...