Craftsman 32017088 screwdriver

User Manual - Page 8

For 32017088.

PDF File Manual, 20 pages, Download pdf file

Loading ...
Loading ...
Loading ...
burst, causing personal injury or damage.
Do not use Power unit outdoors or expose to wet or damp conditions.
Water entering charger will increase the risk of electric shock.
= Use of an attachment not recommended or sold by the manufacturer
may result in a risk of fire, electric shock or injury to persons. Following
this rule will reduce the risk of electric shock, fire or serious personal injury.
Do not abuse cord or power unit. Never use the cord to carry the power
unit. Do not pull the cord rather than the plug when disconnecting from
receptacle. Damage to the cord or power unit could occur and create an
electric shock hazard. Replace damaged cords immediately.
Make sure cord is located so that it will not be stepped on, tripped
over, come in contact with sharp edges or moving parts or otherwise
subjected to damage or stress. This will reduce the risk of accidental falls,
which could cause injury and damage to the cord, which could result in
electric shock.
1.
.
3.
Keep cord and power unit from heat to prevent damage to housing or
internal parts.
Do not let gasoline, oils, petroleum=based products, etc. come in
contact with plastic parts. They contain chemicals that can damage,
weaken or destroy plastic.
An extension cord should not be used unless absolutely necessary.
Use of improper extension cord could result in a risk of fire and electric
shock. If an extension cord must be used, make sure:
That pins on plug of extension cord are the same number, size and shape as
hose of plug on charger.
That extension cord is properly wired and in good electrical condition; and
That wire size is large enough for AC ampere rating of charger as specified
below:
Cord Length (Feet) 25' 50' 100'
Cord Size(AWG) 16 16 16
NOTE: AWG = American Wire Gauge
Do not operate the power unit with a damaged cord or plug, which could
cause shorting and electric shock, if damaged, have the power unit repaired
or replaced by an authorized service technician at Sears Service Center.
Do not operate power unit if it has received a sharp blow, been dropped
or otherwise damaged in any way. Take it to an authorized service
technician at Sears Service Center for an electrical check to determine if the
power unit is in good working order.
Do not disassemble power unit. Take it to an authorized service technician
17088 Manual Revised 09-0728 Page 8
Loading ...
Loading ...
Loading ...