Loading ...
Loading ...
Loading ...
MAINTENANCE
EZT belt
To replace EZT (E-Series Zeroturn
Transaxle) belt
Park the mower on a level surface. Engage
the parking brake.
EZT belt removal
NOTE: Be careful not to damage the fan
blades on the EZT's as this can affect cooling
or damage the EZT's
Remove the deck belt (see to replace
deck belt in this section of the manual).
Unplug clutch from wiring harness.
Remove bolt from center of clutch and
slide clutch off of engine shaft.
Create slack in the belt by removing the
spring on the pump idler arm.
The belt should now be able to be
removed from the engine pulley and
EZT pulleys.
Belt installation
Wrap the EZT belt around the EZT
pulleys
Route the belt around the inside of the
idler pulley.
Now you can wrap the belt around the
engine pulley.
Reattach the spring on the pump idler
arm.
Install clutch on to engine shaft (pulley
side down) make sure key is installed
and align the clutch anti rotation tab into
slot on clutch. Secure clutch, install wire.
Reinstall the deck belt onto the electric
clutch belt (see to replace deck belt in
this section of the manual).
©
Transaxle belt
English-44
Loading ...
Loading ...
Loading ...